开云体育

Hello all, I have three nodes and all have port forwarding enabled and They have no problem with an external connection. But when I try to connect to one another on my home network I get connection

Hi Mark, I have uploaded the document to the File section of this group. /g/SHARI/files/Suggested Change in SHARI Setup.pdf (

I purchased a PiZero Hat that included updated instructions for setting up the audio with simpleusb. I have misplaced those instructions. Is that document available or can the new settings be given

I put his code in a file for you.

channel.sh is the script that I pasted in the email. You would need to create it and modify it with your desired channels and settings. -Michael Sent: Monday, March 6, 2023 12:28 AM To:

Michael; I'm not a programmer but I can get through some things. I'm missing something with your instructions. 1. I cannot find "channel.sh" -- channel1 or --channel2 or --channel3 in

Oops. Here’s the pictures of what error I was getting. The other picture is with your lsusb command. I also tried using the preset frequency you provided and it did nothing…

Thank you to Steve for calling me on the phone and troubleshooting the device with me. It turns out my soldering was to blame. After doing a little cleanup and making sure that the solder was fully

Only one USB connection is required.? Both are wired to provide 5V.? One USB connection is used to program the SA818 (wired to the CH340 USB to serial converter) using SA818-prog..? The other is

both usb connections need to be made for it to work.

Hi Lyle, There is no picture attached. Please send it again.? Also please connect to the USB port closest to the center and type *lsusb<enter>* at the Bash shell (Item 9 of the Admin Menu).? Do you

Hello, I soldered together my SHARI tonight and when I went to program the SA818 I get the error shown in the attached picture. I’m not sure where to go from here. This happens no matter what usb

Any progress with seeing if the other solution works, wr2uhf? (Can you add your name to this group so we can see what it is rather than having to go to QRZ to find it? It's easy to do. Thanks.) --

Sorry to everyone for the late reply. Problem resolved. The Shari USB connectors were not seated well in the RPi USB ports. I powered down the node, reseated the connectors, rebooted and everything

Any one use the microUSB to USB cable that Steve created to connect Pi and Hat? If so, how is it different from the other option of the two wire connection from J5 to TP22 and TP 23? Thanks Ron

ok thanks

COS keyed with no RF input is usually caused by the the incorrect polarity of COSFROM. The COS LED will not light until you modify two lines in the rpt.conf file (/etc/asterisk/rpt.conf) as described

I am setting up a node and the shari sends out the morse code ID, ip address, and time, but whenever I keyup? the shari does not, the yellow light doesn't light and in item 2 of the

SA818-prog has a command-line interface that is not interactive (unattended). It's called?818cli-prog in /user/local/sbin but you should be cautioned that if an error is sent it might be trouble. It