开云体育

False alarm. I guess he hadn't taken the distributor out to inspect it. Appears that the disk with the magnets was damaged. I think he also ha s wiring issue, since the 12 volt red wire running to the

Bill, If he won't read voltages, he probably won't read resistances either. But ask him to remove the wires from the two small spade terminals on the coil, then measure the resistance between the two

I'm trying to help someone out with what sounds like an ignition issue. Stumbling and misfire under load, and on hills and acceleration once the car is hot. He has a Lumination Magnatronic, which I

I didn’t mean to come off as complaining about the price of $21 to ship a cam pulley from the UK. I thought it was pretty reasonable. I was just throwing it out as a data point in the conversation

It's 2022, and the world is in a rather different place than where we found it 10 years back. Perhaps our friends in the U.S. are well sheltered by way of so many merchants offering transport free of

I think we can bring this topic to a close as I started undoing the connections between the little black oil tube and the sending unit, I discovered that the last coupler at the sending unit is a

Parallel male thread into tapered female, or tapered male into parallel female, not tapered into tapered. Parallel to parallel with a sealant or mechanical seal. I tend to use a low strength loctite

1/8 BSP would have been my guess but I haven’t checked. Remember that BSP threads come in 2 styles BSPP and BSPT. P for Parallel threads and T for Tapered threads. Parallel threads would seal

I think the thread on the connector that is on the engine is 1/8 BSP.

Tim,?Thanks. I'll give it a go although my expectations are not great. I live in the middle of the Puget Sound region nearby all the major hardware stores. The last time I was in my local store I

Jeff, It's been a long time, but... When I needed to replace that oil pressure fitting, I was living "out indah woodts" in northern Minnesota. The nearest town (300 people) had a small hardware store.

You might be able to do a washer for a bit less but It just cost me $21 to ship a single cam pulley from SJ. Dave C

Bill, Polyimide (eg, DuPont Vespel) is a thermoset resin that is used to make high performance bushings and washers. It was first developed for use in jet engines. I've contacted one internet vendor

Well, never felt that way from SJ with them always responding promptly and even taking phone calls early in the morning and shipping a pretty big order right away when there was waiting for example on

WOW. For a small box, that is incredible, but understandable given the cost of jet fuel these days. Plus, I’ve heard that Steve doesn’t really like us Yanks, so don’t go out of his way to find

Seems that shipping costs have increased substantially from SJ as well. I have a shipment in transit for various small stuff in the amount of $265 with shipping costs of $165.??Jeff?Sent from my

I just paid $21.49 each from a US Lotus parts supplier for the Nylatron pilot bearing thrust washer, A079F4029F. Price at SJ was $7 plus shipping, but the wait could be a couple weeks. I am NOT

Hello all, I'd like to know best way to test oil pressure in my 907 engine.? In particular, I have a oil pressure tester/gauge but need to know best place to access oil pressure and size of fittings

I just installed a 123 distributor in an 84 Turbo Esprit. I haven’t run it yet so my opinion so far is based on installation and setup. It’s on the pricier end but it is a complete new

Great. That conversation was 2 years ago. I bought the FAST system, and it has been sitting on my bench waiting to be installed. Bigger problems came up, and cars, boats, and trailers came and went.