开云体育

But 0.17.1 is available on Oleg's website. https://r1cbu.ru/index.php/home/radio-software/x6100/13-firmware-v0-17-0 The link says 0.17.0, but on that page you can see that it is actually 0.17.1

Please try not to post the same question 3 times to the same group, that is generally considered to be very very rude.

good evening, can someone send me the r1cbu 0.17.1 firmware please, antoniojoselop@... thank you 73 ?

good evening, can someone send me the r1cbu 0.17.1 firmware please, antoniojoselop@... thank you 73 ?

good evening, can someone send me the r1cbu 0.17.1 firmware please, antoniojoselop@... thank you 73 ?

I only use my X6100 while plugged into a DC power supply. Is there any way to set the screensaver so the screen stays on until the radio is turned off? Thanks, K5UTM

Used this firmware for the first time today on SSB. I like it; however, when I tried to operate CW, I realized I have to add settings for my preferences; eg Iambic settings. How does one do

I rebuilt hamlib to latest and greatest version. 1. x6100 works find instead of 5105 2. rigctld works great. 3. flrig still doesn't work. so, for now, i'm done with flrig Jerry ---- Extra Ham Radio

I found out you couldn't just use -L you had to specify the radio and then -L so ... rigctld -m xxxx -L I had no trouble with x6100, but I just rebuilt the hamlib with the latest and greatest

rigctld -m 3087 -r /dev/ttyACM1 -s 19200 -C stop_bits=1 & This works for me on Linux mint with stop_bits not stopbits. See the man rigctld. Use regctld -L to see all devices. For JS8 I need to use

I also use linux mint and v19 - everything works fine. I assume you are using cmedia input/output on the audio page, so the only thing I would try is setting the device to x5105. I think sometimes

Had not run R1CBU with FLrig. Tried both R1CBU 0.17 and 0.19 with FLrig 1.4.7 with same results. FLrig to talk to X6100 using FLrig's X5105 driver. best with the Xiegu fw In addition, FLrig would

Thanks WF5W - was struggling with JS8.

Ok. Update. It does work. Flrig somehow won't talk to it. But if I use hamlib DIRECTLY, it all works. $ rigctld -m 3087 -r /dev/ttyACM1 -s 19200 -C stopbits=1 & and set all my digital modes to use

I've been using it for all digital modes with my Surface and it works flawlessly. The only time it acts up is when the battery is low. This firmware is light years ahead of the stock. Good luck!

Ok. Not clean but I got both ft8 and js8 to work. Flrig would not work in any case. FT8 works with newest version of hamlib JS8 only works with command line rigctld Jerry [email protected]>

Ok. I have tried everything known to mankind, to get digital modes to work with R1CBU. It was my understanding that R1CBU was just a different GUI, on top of the radio. It is NOT. So at first I

My cat control no longer works with v19 R1CBU. I am running on linux mint: My radio is at latest firmware revision (from Radioddity - the one that says "fix Cat") 1. I boot up as default

Please close this issue. It was a ground loop problem. Pesky things those grounds! Gotta connect them in the proper places. Still not sure why RICBU firmware was more susceptible.

I too had the same problem with my x6100.