开云体育

Hi Fabrizio, I’ll put together some images, notes, etc and share them on GitHub… I’ll let you know when it’s there. Martin Sent: 12 December 2017 19:33 To:

Many thanks Petr. Martin Sent: 13 December 2017 07:13 To: [email protected] Subject: Re: [QRPLabs] Boxing the QCX Martin, it is definitely best housing I ever saw until now. Big big

Hi Daniel, Argo works fine under Wine. QRSS-VD is quite good but is a little more involved to get running. SpectrumLab works ok under Wine and is another good option to try. 73 Simon G0FCU.

Planning to run my U3S on at least 30m FSKCW6 and WSPR, but got curious on the receiving stuff. I run Debian linux in my shack and have tested Baudline for qrss viewing. Almost everyone talks about

"Any suggestions welcome" ... Enno, Suggestion, what about the ratio? L4 vs C30 ? Maybe a turn or two plus or minus at L4. Thanks for the QSY tip :>) 72 73 John N3AAZ

Dear group, I have built a QCX 30m (#1229). Building went straight forward. I could peak the input filter nicely with the trimmer in the mid position. However output power was a bit low: 2W with

Are you using as switched mode power supply, the logic in the U3S likes clean dc supply preferably from an analogue supply.?? Just my observations.? Cheers and 73.

Hello ALAN , I have testing with 100?h inductors,the résults is the same 73 jo f6cht.

Earl, could you show the front view of your panel mounted QCX? I like the idea of mounting my next QCX that way. Thanks, Julian, G4ETS.

Martin, it is definitely best housing I ever saw until now. Big big congrats for excellent job. I will probably copy it :) 73 - Petr, OK1RP

Hi Jan, The 14.100 frequency was only for example to explain the display wrong indication on qcx. Fabrizio Inviato da iPad

Hi Fabrizio I hope you have not really set it up to beacon on 14100. You would then QRM the?IARU/NCDXF? beacon network. 73 Jan

Thanks Martin! I think the alu box needs 6-10 days for Italy delivery... Do you have the drlilling sheet for lcd and qcx pcb? Many thanks Martin. P.S.sorry for my basic and school level english...

Hi Fabrizio, if you need any help getting it in the box do email me or contact via facebook. I’ll help you all I can. Martin Sent: 12 December 2017 17:06 To: [email protected] Subject: Re:

Just bought it! Many thanks! Inviato da iPad

I'm tried to setup the cw beacon. Write msg on first position, beacon on, frequency 14.100 (for example), frame 01.... the qcx start to trasmit on every minute the message one. The bug is the shown

Hi Mike, you HAVE read the caveat that I haven't printed this version yet - although it looks fine in an assembled model with my board reference model. For the short case you need: 1

I used the Hammond box for mine as well - It was a rather tight fit due to the pillars inside for the screws holding the box together. ?I had to trim the corners of the board on one side to get it to

Martin, Thank you. Those look like very nice enclosures. Jonathan wrote:

hello Alan i have 20mhz good and 27mhz good thanks for your hep today? i have receved encodeur sending by Hans but receiver is shudown just bf running 73 jo?l