开云体育

/ //Hello Wes and all wanting remote switches in a QCX// // //My detailed discussion with Hans assures me that _all_ the// //_QCX switches / key inputs_ are are debounced in firmware// //so that

Well, I haven’t found the perfect enclosure (this one isn’t for me) and I haven’t yet found an affordable die punch for the LCD screen hole, but I did buy a 1x16 male pin strip and a 1x16 ribbon

Thanks for WSPR info 73 Barry NF1O

Hello Chris, Unfortunately I have no big amp of that type. I will be building a 25-50 watt HB9ASB LF/MF amp as described on the QRP Labs site. Apparently it benefits from somewhat more drive. My RX

The replacement processor for my (early) 30m QCX arrived and the trx works. The rx is absolutely great. My list of qsos is growing, even I'm currently bound to daylight qsos :-). The Trx Power is abt.

Here is the link for the balloons,?Balloons (

I think I can be more patient waiting for my QCX. I really have no other choice. The daunting medical appointments are evaluation for a liver transplant. This is just what I have to go through just to

Hello Robert. You should of heard me ranting to the suppliers of my drone HiHi. FIVE MONTHS..!!!! Heart and lungs at this QTH.!! With the medication I'm on, I can lose it on the flip of a coin.

No, it will most likley not fit, you have quite some u3s builds here, have a look:??http://qrp-labs.com/ultimate3/u3builders.html

My U3S has the 5W PA, single band operation and the depth front to back in about 120mm. I don't use the QRP Labs case. But, I'm going say I don't think a GPS board and the U3S with the amp will fit in

Hi Mike The fuses ARE already set for the 65ms start-up delay. There should not be any large power jumps on start-up. It's a bit of a mystery why some people see it and some don't. I never get it

This is a build that I’m actually excited about. When I read about the kit somewhere I was really intrigued with the many features included. Robert (N5RHA) Sent: Thursday, October 12, 2017 2:06 PM

Hallo Hans, I do not have any experience with AVRs. I read in the datasheet that you can set the fuse bits for a time-out-dalay after reset of about 65 ms. This should be enough for the the 100 microH

Hello Robert Thank you; but don't worry about it. I know waiting is frustrating. Sometimes for whatever reasons, our tolerance of frustration is diminished. It happens. I wish you the very best of

I wanted to just send a little note to apologize for my rant about the shipping delays. I have been really stressed lately due to health problems. I hope that none of you ever need to have a liver

Great going, Mikael! I’ve been following your and the other WSPR balloonists’ posts on here with much interest. I’m anxiously awaiting the U3B to appear in the QRP Labs shop, and my goal

You're on an interesting quest Justin. I can't help with any paddle hardware but on reading your message I immediately thought of the "Solid State CW Paddle" from Neno, 9A5N. Maybe this could help in

Hello all- I’m curious if the 5w amp will fit in the 3S enclosure with every option including the GPS board installed, which from videos, appears to require both a 5v and 9v power supply board?

All - please ignore, I have emailed with Paul. But accidentally approved the message sending... 73 Hans G0UPL wrote:

Hi, I subscribed to your group and got the typical emails when subscribing… am getting peoples messages as they add them to my inbox, however: when I try to edit the settings I keep being told that