开云体育

Stan, I have been using quisk while trouble shooting with IQ active.? ?I only use linux here so no NaP3 or HDSDR. I get a stream coming into the sdr software but the noise floor is very very low

Hi, I received my QMX+ kit two weeks ago. I carefully constructed and tested it. It works perfectly on CW, on all bands. I don't operate digital modes or SSB so I haven't tested those modes. I've been

It keys but no output and when I type in keyboard and hit enter with TxID off also no output.

Hi Stan, Fldigi is working and when I press tune, in RTTY mode there is output, but in CQ it appears in the window, but no keying. The TxID light comes on but I turn it off. This is my first time in

I love the iFTx with the QMX. Those are some good QSO’s there. I see the signal strength and power in DIGI mode as with the others. Using VOX, I did need to lower the thresholds a little but it is

The one issue I have had with the front panel button is that it must be plugged in with the correct polarity (despite what Sardar's original instructions say) - this is because one side of the switch

Here is how I do it: 1 - I use 'flrig' for QMX control? (Hamlib will also work if you like it better and know how to set it up). a) first, in fldigi configuration 'Rig control' click on fldigi, and

Sorry for the long delay between questions. The speaker, amplifier, and battery manager appear to be working. The ATU worked fine in isolation. However, after plugging everything together, the ATU

The Bioenno 12V batteries should not be used with QMX/QMX+ unless you use diodes to drop the voltage.? Their full-charge voltage is much higher than 12V. Many have reported using the 12V Talentcell

Cool. what tuner did you use?

Hi John, Thanks for the suggestion! When I go to download a copy all I get is an unconfirmed download and the file goes away after a few hours and never seems to complete...? Any suggestions?

Most modern equipment thrives at 13.8 volts, and how low in voltage they will operate varies. The QCX family of CW rigs generally works at this same voltage. The QMX family supports more diverse

I will check all of this hopefully tonight. Thanks for the responses. Ryan KK6DZB

Yes, Todd is correct. a) The QMX only will show up as a 'virtual USB storage drive' during firmware update mode. b) If the USB connector is connected to both computer and QMX, then you power-on QMX

Alain, I believe the drive only pops up when you're doing a firmware update. So if you go through the same firmware menu process, the simulated flash drive will pop up again. When you plug in the QMX

Greetings all, So yes a firmware upgrade issue. But I have not seen this particular issue or this process described. Fully updated windows 10 Tried all 6 USB ports on my PC Rebooted multiple times.

Howdy all, I finally was able to get the QMX on the air last night since having it for over several months now. Mine is setup for 9v and I’m using a wall wart tO power it at the moment. It worked

I agree with the buck-boost converter. What I use has a 4amp capacity and 7-30Vdc input. The C.V. and C.C. are set with pots. It also has a color LCD which shows: input voltage, output voltage

I can recommend the 12v Talentcell battery with the QMX (not the +) or for the QCX-mini, the case is conveniently the same size as the radios. They perform well. Steve

I purchased the development kit with my QMX+ because I thought maybe I'd install a tuner. I did and although I can't? drill a hole in the right location to save my life, out of laziness for sure, I