开云体育

hey group first of all: I am eagerly watching my ordered QDX running up the waitlist, so I have no device in hands right now. still I thought I get perpared and read the docs and some topics here.

Hello all, I've just acquired a secondhand QMX. It's in mint condition, has a Rev 4 PCB, and was factory built (supposedly). It works perfectly fine, but the X502 jack appears to be very slightly

Daniel Conklin via groups.io <danconklin2@...> wrote: But what if we only compare their receivers? Like apples to apples. There's a signal and an antenna -- same signal and same

Thank you, too, Tony. 15 Oca 2025 ?ar 05:59 tarihinde mux_folder2001 via groups.io <canthony15= [email protected]> ?unu yazd?:

Open the band configuration screen with Putty. Use the right arrow to move to the right. When you get to 20 Meters another right arrow press will scroll the window so you can see the next

Ah! Great info. Thanks a lot. 15 Oca 2025 ?ar 05:58 tarihinde Stan Dye via groups.io <standye= [email protected]> ?unu yazd?:

The screen scrolls to the higher bands. Move the cursor across to the right and keep going.

Nope. It is configured for 160-6 but there are no values listed in the manual under Putty's Band Configuration menu, except for 5 bands. Seeing the post on how to block certain bands, I am concerned

Bekir, it sounds like you may have your radio configured as an 80-20 meter QMX instead of as a 160-6 meter QMX+. Ron [email protected]> wrote:

After the initial fifteen seconds of 13.8 volts, I switched to 12 volts. Maybe I should try 9 volts. Dave K9SW

I want to do the exact opposite of this. I want to be able to use my QMX+ on all bands, especially the upper bands. However there are no values listed for bands higher than 20m in the Band

Great visual guide to soldering.? Thanks for posting ! Jim WB4ILP

Nice work and very Cool ! Jim

Bernie Poskus, KF0QS via groups.io <hamdan@...> wrote: Never turn it fully clockwise. If there was an intermittent connection and it accidentally went away, you'd destroy the

Adam via groups.io <qrp-labs@...> wrote: Here's a follow-up. I ordered SI5351A, this

Have you tried 12.0V? -Chuck Harris, WA3UQV <K9SW@...> wrote:

Dear Folks: I have finished building the 50 watt amplifier kit for the QCX.? I am trying to run the test on page 66 of the manual which simply requires you to do the following: 1)? Make sure that

Thanks, Chuck. I’ve tried many variations, factory reset, restarts, using SWR meter and dummy load, so no high SWR concerns. Still no output or input. I’ll work on it some more and see what

Mike, /g/QRPLabs/message/131060 ( /g/QRPLabs/message/131060?p=%2C%2C%2C20%2C0%2C0%2C0%3A%3ACreated%2C%2Cm0ktz%2C20%2C2%2C0%2C108865966 ) plus: in a big forum like

Thanks Don, This is new information to me. I did not look beyond the red and black pairs. I did think about color coded wires. I am using 14 gage red and black wire. Those other combinations would