Hello all,
?
I've just acquired a secondhand QMX. It's in mint condition, has a Rev 4 PCB, and was factory built (supposedly).
?
It works perfectly fine, but the X502 jack appears to be very slightly off-centre in one direction. Looking at the QMX from above, the jack is at right angles to the side plate, which is as expected. Looking towards the QMX when it is flat and the X502 is on the right, the jack is slightly tilted upwards: the angle between the washer and the end of the jack is probably only one degree at most.
?
Is this cause for concern? I can live with it if there isn't any undue stress on the connector, but can also do a bit of soldering to straighten it up if this is the recommended action.?
?
Help please!?
?
73 de M7HAI?
Adrian
