开云体育

Hello Gary According to the US 60m band allocation there isn't any tuning range in a channel. The channel is what it is, a fixed frequency. (though it's not entirely unambiguous in my opinion). If

Hans, My observation when the "RX outside band" is set to OFF, it tunes between the centers of the 60m channels OK, but I did not find a way to tune around within the channel. Since it is unlikely

Ok Thanks Andreas I need to fix that then, for sure. 73 Hans G0UPL http://qrp-labs.com https://buymeacoffee.com/g0upl [email protected]> wrote:

PS: 1.5MHz is wrong - it's either 3.50000MHz on digi mode or 3.50150Mhz on CW. Same for the 4.something MHz where it all starts: it's either 4.00000MHz or 4.00150MHz. Between these limits, anything is

Hans, I'm really starting to feel sorry for luring you into sideshow discussions like this but you got me wrong: It does not jump around at the ends on any selected band. This statement was more of

Hi Ronan Is it still the same in the latest 1_00_023 or has it been resolved as a side-effect of other changes I made? 73 Hans

Hello Andreas It shouldn't jump around to ends of bands. I'll have to investigate that and try to reproduce it. It should just step between the 5 US 60m channels. So I'll investigate that and a few

I’ve been using these for a while and they work great and only a few dollars on Amazon. Very thin so sits lower then the rubber feet when not used allowing the choice to still use flat on a

Hi, I agree that every ham should be aware of the right band limits for the country he's currently working from. It's more of a convenience feature, especially if the frequency would just jump to the

These are just data points, not complaints or bug reports as they each have only occurred once and have no clue how to reproduce them. 1 - in SWR/Tune mode, with a measurement in progress the

Isn't that what the QMX basically is?!

Recently I've been practicing SMD work with some inexpensive kits for that purpose I found on Amazon. I had also ordered some ChipQuik liquid flux along with both leaded and unleaded ChipQuik solder

I'd love to build a multi-band QCX-mini. Just sayin... .rr

You tease :D

Hi Samantha I'll have to start designing some new kits for you to build! 73 Hans G0UPL http://qrp-labs.com https://www.buymeacoffee.com/g0upl

I can't follow it when I follow it ??

*Maybe follow this topic /g/QRPLabs/topic/praise_for_the_new_cw_filters/107654203*

Hi All, I am 'cerebrally challenged'. I see the new menu item CW Filters. Explain how and when they are used. As to how I became a ham. I was impressed by the Admiralty and very liable to mutiny when

I have the Hakko desoldering kit and it’s great. I find that it alone can not do the whole job on some smd,but it’s valuable to remove all the solder. Much better than the solder wick

Get two Power supplies Set them both to the recommended voltage in the instructions If you have too much power going into the amplifier buy some 5W metal oxide film resistors to increase the input