开云体育

How about just investing in a good old Boat Anchor radio. eBay would be a good place to start. Mike Krieger [email protected]> wrote:

I highly recommend the QRPoMeter (kit) .? It has a 3dB pad to protect your radio while tuning and showing accurate SWR.? It also has a good dummy load and reads out accurate power.? The display is

Buy yourself a WWII vintage valve transceiver set.? ?Three strong men can probably get it all up the stairs but the floor may give way. Remove and dump the contents of the chassis and replace them

Folks, a few weeks ago I was assembling my QMX+ and thought I had messed up my QLG3 module, so I ordered a replacement. Shortly after placing the order I realized that I could repair the damage done.

Hello Kevin QLG2 could be wired to a 3.5mm plug and connected externally to the QMX+ Paddle port in the same way you'd use it on QMX. If you want to install QLG2 inside then assuming you'll take care

Thanks Chris! I will give it a try! Fingers’ crossed! Joan

Hi Onur, The RX/TX audio streams between iPhone and QDX/QMX are always purely digital via the virtual USB sound card that's implemented by QDX/QMX firmware. So you won't be able to hear anything. The

Hans, Sure is good to see the net drop in the backorder queue from the high of 900 assys. 73 Kees K5BCQ

Hi Hans, I had asked the following question awhile back: I have a QLG2 lying around. Since I acquired the QMX+ from you at Hamvention, I thought about using it Inside the QMX+ as it has a lot of

Sorry for dividing this up into so many posts. Does anyone have a tip where to look to get the receiver going. By the was the 2 buttons do work if I go into the menue. Martin DK3UW

Diagnostics I had an issue with the 2 buttons as I soldered them on the wrong side of the board and had to remove them. I later checked R 301 and 302 and the switches seemed to work.? I have not

Test ADC I/Q not sure what that means

LPF Do I understand it correctly that on 3.5 Mhz I am 20 db down ?

SWR Sweep with dummy load. That looks ok to me.

image Sweep

RF Filter Sweep

I managed to get that PuTTY to start. Audio

We had 10 folks attend the Michigan QRP Club Zoom meeting last week where the topic was keys. Pete WK8S Ed AB8DF Ernie W3ETE Stuart M0SGV Dave N8SBE Muhsin TA1MHS Rick K8MBA Jeremy KD8ZZJ TBD TA1HMG

Thanks Zhenxing. I did the installation exactly as you described, but unfortunately no activity was seen on the screen. I can try again by changing the cable and adapter, but I need to be sure of

Thank you Gary. I used it at home for a long time with a pi 3 and then a pi 4, as you described. I wanted to try my luck because it was portable and I didn't have to deal with too many devices.