开云体育

Li-Po batteries and others hate being discharged and an audible low battery warning would be welcomed. Jean-Claude

Please understand this as a valid request, no flames between CW and Digital operators please! I operate both modes, but I am primarily a CW Op, though I love and used Pactor, ARQ, etc, and PSK31, so I

A menu item to allow for the 10 Hz tuning step to be enabled or disabled in the rotary control push operation cycling through steps, and, for 10kHz, and 100kHz to also be optionally enabled/disabled.

I have several questions, along with a description of what is happening. First, an observation (1.00b version on 30m): menu items don't seem to take hold until you go back into the menus, perhaps a

Actually it is a problem because even if the files are judicially updated, sooner or later there will be some overlap and the remote file, so to speak, will be out of date. This bit me once when the

My clock puts on about 1 minute or more a day, so WSPR is only working for a few hours at most, and then only works with those who also have their timing way off... Is there any way to correct this,

Hi Wes, Just a suggestion that in the PDF files if not already done so, you refer to the URL to check for latest list, because perhaps the modifications get updated but your files don't? I'd think

In my case when I first had part of T1 connected wrongly, it was the same as I remember in audio set up. With that fixed the audio is now uniform gain, before I had it only slightly open and it would

I have taken the liberty of creating four pdf files containing extracted information from Hans' write-up on the QRP Labs site regarding suggested mods to the QCX. I have posted them to the Files

Very nice, well done. I have? been resisting getting a QCX but now I am going to have to get one so that I can try and duplicate this. cheers, Graham ve3gtc

Ha, excellent. I agree, make your own... Steve MW0KST

Barry Possibly a part is loose. It happened to me while installing into the case. With the test source on, touch various parts,? particularly around the op amps. The resistors standing up have a

Hello group! Just finished building the QCX transceiver and I have an issue.? First let me say that the rig fires up and things look normal.? But when I go in to set the Peak BPF,? the audio is not

I've just tried to run Zadig and install the drivers without a James, This sounds dangerous. Zadig assigns drivers to the selected device. One has to be very careful, only if the required device is

If you click on the "More information" button and select WinUSB (libusb) then this will take you to a website explaining a great deal. Interestingly it says "Older versions of the driver have a bug

Julian, I've just tried to run Zadig and install the drivers without a device even plugged into my machine and it installed the WinUSB driver anyway. So run Zadig, install the drivers one at a time

Hi Julian. I'm pretty useless with computers too and most other things. But, I muddle through and want to help where I can. Zadig is a driver installation program that is very useful to install

" What programming dongle are you using.?" Hi James. I'm following the How To document from the QCX page of the QRP Labs site. It's written by Simon, VK3ELH. It uses an Arduino Uno as the programmer,

Nice job Ken! Joel N6ALT

**Very** neat !! -- Regards/73, Enno, PF5X