开云体育

Thanks Hans and Steve. Monday night back on the bench with my QCX. Thanks for the feedback. 73 de Eddie ZS6BNE [email protected]> wrote:

Hi Jim Just set "6.1 Beacon" to "ON". This means the QCX will power up in beacon mode, and start operating as a beacon in whatever mode you configured (CW or WSPR), with the parameters you configured

All, Anybody know what the setup needs to be to allow a QLG1 GPS unit to work with the QCX Transceiver so that when the QLG1 is plugged into the QCX GPS header the transceiver doesn't start

Hans, Agreed. I had not noticed any major delay when starting with a discharged battery. But I was unhappy with the frequency accuracy of the "GPS disciplined" ProgRock and was attempting to repurpose

Just tried the diode acress the pins, makes no diffrence at all. Dont think im cut out for kit building.

Or a perspex laser cut one :-) PeterO G0DZB

Sounds like a more fundamental problem to me. If it doesn't even start after a quick power-down power-up sequence I don't thing the diode will help. PeterO G0DZB

Thanks Jack 73 Hans G0UPL

Hi all Don't worry too much about the battery. The QLG1 design process took inputs from a number of different sources. As others noted, the module datasheet is very vague. The battery connection was

I found the battery was not charged in my unit. That's why I started this thread. I cannot understand how a 3.3V supply will charge a 3.0V battery through a diode. The 5V supply might work although

foam tape to the inside of the cutters trim with a razor blade generally, it will hold the bit you've nipped 73, -bob ah7i

It is neither a high voltage nor high current application. Just about any small Schottky diode should work. <simon.oliver90@...> wrote:

Alan, Yes, the RF module's description is confusing. I couldn't ascertain whether pin 22 (Vbatt) would source current to charge the battery or not. By measuring the battery voltage in my unit (it

Still cant get my QCX to display anything other than blocks. Not even got to the alignment part yet. Might the Diode trick work? I have a spare Schottky Diode but not sure of its specs.

My application was approved on October 25th. I applied on September 20th. Al, N8WQ

place a small bowl at that distance HI (; I usually hold the cutters so that my index finger is on the end of the pin that I'm cutting, this way it just falls off when opening the cutters... the pin,

I have repeated this info from Hans. 73 Ken G4APB Sent: 10 March 2017 09:18 To: [email protected] Subject: Re: [QRPLabs] What is the Jumpter configeration on LPF board NOT to have all ouputs go

I second Pete's suggestion, a full case.?? That would be wonderful!I think many would use it. I am working on the stand now. Paul? K0ZYV To: [email protected] Sent: Friday, October 27, 2017 9:58 AM

What do you mean regarding encoder noise ? Make sure you try Hans solution as well, /g/QRPLabs/message/17414 It makes sense as you have already tried lowering C47 and it has an effect

Nice work! It printed nicely. Now it would be really great if you or someone with design experience could go to the next step and make a full 3D case for the OCX.? Thanks again Phillip.? Pete WK8S