开云体育

Hi Sergey I could... but, it would take unnecessary time, and, I believe you! I suppose VARA just isn't putting out full volume. QMX in SSB mode is set up so that full volume from the PC means full

Hello Moritz This problem is not a new one with the SSB firmware. It may well be related to the issue that you have to power on your PC, before you power up your QMX. On Windows. Again something that

playing around with the LC; CAT command.... if there are "." on the cw decoder, the LC command does not display them.?? Instead of outputting 32 characters you get less and less the more periods

I have a newly built QMX+. Still on the dummy load. 1_01_007 beta firmware. I'm attempting to measure power output using WSJT-X in Tune mode. I've done this before with a QDX and a QMX. I cloned my

Beta 07 works fine with Win 10. All three COM ports can be enabled. Not so with Win 8. It sees only two ports no matter will one choose 2 or 3 in QMX menu. And there are no CAT control in WJST-X or

And here starts the whole description /g/QRPLabs/message/143940. 73 Ludwig

Hi Hans, Hi all, after performing a firmware upgrade, the device appears to experience an issue with USB connectivity. Specifically, although the new image may be written successfully, the USB

No, if you are referring to the System config setting 'PTT as Serial 3', don't use it.? That refers to using the PTT output connector as a second serial port, which is not fully supported and

Kai- I recently completed assembly of my QMX+ kit (rev 2, 12v).? It does receive, but it doesn't seem to be as sensitive as it should be. I just wanted to let you know that ?I've been following your

Hi Hans, i can confirm, the connection/driver issue with Windows 11 and the 3 serial ports is solved with Version 1_01_007. Thank you very much, that was quick! -- Moritz, KO6DZX

If you know the QMX / + menu well, and are experience at using Google Documents and want access to edit the above file online for everyone's benefit let me know and I will make you an editor.

If anyone want to have a Google Drive version of it to correct, update, simplify, make more useful. Then make a copy of this Google Document and have at

Hello Hans, you are quick! Sorry, the same problem like written here /g/QRPLabs/message/143970. Maybe not a USB problem? 73 Ludwig

Will setting this to on allow PTT via one of the three USB comports (not cat)? I have some older apps that would benefit from this.

This sounds like you have an intermittent or bad connection between your front panel and the QMX+ main board. Use a magnifier to check carefully all of the soldering of those connectors, and also that

This _007 release fixes all 3 COM ports on my fully-patched Win10-home edition. Thank you! Stan KC7XE.

The following items have been added to the Files area of the [email protected] group. * /QMX Menu Reference.docx ( /g/QRPLabs/files/QMX%20Menu%20Reference.docx ) *By:* Paul K7VIQ

Does anyone know about any small manual (or auto if it works with qmx) tuners that can handle 70w? I am building a 3d printed case for my qmx, and an amp. I need a good light

Mine worked great with two ports enabled then I enabled 3 ports and it dropped all 3 com ports after 10 minutes. I'm going to try again!

Hans … Version 007 fixed my problems with Win11 dropping ports after 10 minutes or so. Everything playing nicely now for an hour. Thank you for all you extra work on this! 73 Dick,