开云体育

Hi Steve. That's a very interesting issue. I was thinking that if you haven't fitted the AGC option in there, then you might take that little circuit board included with the kit for the purpose of

Jake, on that IC6 pin 5 short to ground, can you verify the actual resistance being measured to ground with the ohm meter from pin 5 when you get a chance? Some continuity meter measurements will give

I think that was Alibaba delivering my uSDX. -- Colin - K6JTH http://tangokeys.com

I just finished building a QCX-mini for 10m. I ended up with: T1 T50-6 (yellow) Primary: 4T Secondary 1: 4T Secondary 2: 4T Secondary 3: 14T L4 T37-6: 5T L1 & L3 T37-6: 9T L2 T37-6: 10T On RX

After further checking using the continuity tester on my multimeter, it appears that pin 5 of IC6 has continuity to ground whereas pin 3 does not. I would assume that this should not be the case, and

Blow me, it gets curiouser and curiouser...? I've now found yet another document: https://www.cdebyte.com/Uploadfiles/Files/2022-7-19/2022719168153093.pdf. This mentions another command, number 121

The object of our Military is to NOT have a "fair" fight. Peace thru superior firepower. 73, Tim KB2MFS [email protected]> wrote:

Totally agree John!

"Measuring Response-Times"...

Sadly they are 'Hogtied' until #47... ;)

ROFL!

My wife and my daughter asked me about this “Chinese spy balloon”, I told them “Don’t worry, they already use Tik-Tok to spy on you.” 73 de Robert, OE7OER Von: [email protected]

Just been shot down over sea. Recovery teams out. -- - 73 de Andy -

Extra style points for monitoring the power supply with a 'scope to catch any overshoot on turn on/off. 73, Don N2VGU

Actually it would be interesting to know why one of them did not need a trunks change, and not all of them. I have one on the bench that I have not put much more on it since I installed the schottly

Jim, I’ve tuned up several 20 meter QCXs and all but one required 2 less turns on L3. But it’s always easier to remove turns than to add them so keep That in mind. 73… Ron [email protected]>

With it in the condition you mention where it’s generating what sounds like the 700 Hz test tone even though you aren’t in that test mode, it would be best to use a scope and see which stage is

Yes, and nobody remembers '/Project Genetrix/'. 73 de LA9XKA - Per -- Denne e-postmeldingen er sjekket av AVG-antivirus. www.avg.com

I'm building my third QCX+, this one for 20 meters. Getting close to the point where I wind L3. On my 30 meter unit I had to clip a lead, remove two turns, and re-solder the coil to the board. As Hans

Factory resetting didn't help. What would I be looking for in terms of oscillation in the filter stages? Are we just talking about either a short between the input and output of one of the op-amps/a