Dale, be sure the Shield does'nt get claustrophiobia.
It seems a common problem with homebrewed equipment these days.
Probably something to do with global warming or summat. :-)
toggle quoted message
Show quoted text
On 4 Jun 2013 at 18:53, w0r wrote:
Thanks Hans
I set the switches and started Argo and everything seems to work properly.
Now I need to put it into an enclosure and put it on the air.
Thanks again
73's Dale W0IR
From: QRPLabs@... [mailto:QRPLabs@...] On Behalf Of
Hans Summers
Sent: Tuesday, June 04, 2013 5:07 PM
To: QRPLabs@...
Subject: Re: [QRPLabs] QRSS Arduino Shield Switches
Hi Dale
In the sample sketch provided, two of the switches (S3, S4) set the speed:
// Read the switches, to set the
mode and speed
mode = digitalRead(SWITCH1) + 2 * digitalRead(SWITCH2);
ditSpeed = digitalRead(SWITCH3) + 2 * digitalRead(SWITCH4);
and refer to the speed array at the front of the sketch:
const unsigned int speeds[] = {1, 30, 60, 100}; // Speeds for: 12wpm,
QRSS3, QRSS6, QRSS10
So
Switch 3 off, Switch 4 off: 12wpm
Switch 3 on, switch 4 off: 3s dits
Switch 3 off, switch 4 on: 6s dits
Switch 3 on, switch 4 on: 10s dits
Similarly for mode:
#define MODE_NONE 0 // Mode NONE means the Power
Amplifier is disabled
#define MODE_QRSS 1 // QRSS mode (i.e. ordinary CW)
#define MODE_FSKCW 2 // FSK CW mode
#define MODE_DFCW 3 // DFCW mode
So:
Switch 1 off, switch 2 off: OFF
Switch 1 on, switch 2 off: QRSS
Switch 1 off, switch 2 on: FSK/CW
Switch 1 on, switch 2 on: DFCW
73 Hans G0UPL
On Tue, Jun 4, 2013 at 8:53 PM, Dale <w0ir@...> wrote:
Can some on tell me what the switch setting should be on the QRSS Arduino
Shield. I believe I should be running the board QRSS3.
Thanks Dale W0IR
