Re: QRSS Arduino Shield Switches
|
Thanks Hans ? I set the switches and started Argo and everything seems to work properly. Now I need to put it into an enclosure and put it on the air. ? Thanks again 73¡¯s Dale W0IR ?
toggle quoted message
Show quoted text
From: QRPLabs@... [mailto:QRPLabs@...] On Behalf Of Hans Summers
Sent: Tuesday, June 04, 2013 5:07 PM
To: QRPLabs@...
Subject: Re: [QRPLabs] QRSS Arduino Shield Switches? ? ? In the sample sketch provided, two of the switches (S3, S4) set the speed: ? ???????????????????????????????????????? // Read the switches, to set the mode and speed ? mode = digitalRead(SWITCH1) + 2 * digitalRead(SWITCH2); ? ditSpeed = digitalRead(SWITCH3) + 2 * digitalRead(SWITCH4); and refer to the speed array at the front of the sketch: ? const unsigned int speeds[] = {1, 30, 60, 100};?? // Speeds for: 12wpm, QRSS3, QRSS6, QRSS10Switch 3 off, Switch 4 off: 12wpm Switch 3 on, switch 4 off: 3s dits Switch 3 off, switch 4 on: 6s dits Switch 3 on, switch 4 on: 10s dits ? #define MODE_NONE 0????????????????????? // Mode NONE means the Power Amplifier is disabled #define MODE_QRSS 1????????????????????? // QRSS mode (i.e. ordinary CW) #define MODE_FSKCW 2???????????????????? // FSK CW mode #define MODE_DFCW 3????????????????????? // DFCW mode Switch 1 off, switch 2 off: OFF Switch 1 on, switch 2 off: QRSS Switch 1 off, switch 2 on: FSK/CW Switch 1 on, switch 2 on: DFCW ? On Tue, Jun 4, 2013 at 8:53 PM, Dale <w0ir@...> wrote: ? Can some on tell me what the switch setting should be on the QRSS Arduino Shield. I believe I should be running the board QRSS3.
Thanks Dale W0IR ?
|
