Hello Hans,
I have added some debus statements for the switches.
Accordingly, the switch settings and the modes / speed are exactly reversed.
Switch 1 ON, ? switch 2 ON: OFF
Switch 1 OFF, switch 2 ON: QRSS
Switch 1 ON,?? switch 2 OFF: FSK/CW
Switch 1 OFF, switch 2 OFF: DFCW
Switch 3 ON,? switch 4 ON: 12wpm
Switch 3 OFF, switch 4 ON: 3s dits
Switch 3 ON,? switch 4 OFF: 6s dits
Switch 3 OFF, switch 4 OFF: 10s dits
Can you confirm that?
73, Wolfgang DL2KI
---In qrplabs@..., <w0ir@...> wrote:
Thanks Hans
?
I set the switches and started Argo and everything seems to work properly. Now I need to put it into an enclosure and put it on the air.
?
Thanks again
73¡¯s Dale W0IR
?
From: QRPLabs@... [mailto:QRPLabs@...] On Behalf Of Hans Summers
Sent: Tuesday, June 04, 2013 5:07 PM
To: QRPLabs@...
Subject: Re: [QRPLabs] QRSS Arduino Shield Switches ?
?
?
In the sample sketch provided, two of the switches (S3, S4) set the speed:
?
???????????????????????????????????????? // Read the switches, to set the mode and speed
? mode = digitalRead(SWITCH1) + 2 * digitalRead(SWITCH2);
? ditSpeed = digitalRead(SWITCH3) + 2 * digitalRead(SWITCH4);
and refer to the speed array at the front of the sketch:
?
const unsigned int speeds[] = {1, 30, 60, 100};?? // Speeds for: 12wpm, QRSS3, QRSS6, QRSS10Switch 3 off, Switch 4 off: 12wpm
Switch 3 on, switch 4 off: 3s dits
Switch 3 off, switch 4 on: 6s dits
Switch 3 on, switch 4 on: 10s dits
?
#define MODE_NONE 0????????????????????? // Mode NONE means the Power Amplifier is disabled
#define MODE_QRSS 1????????????????????? // QRSS mode (i.e. ordinary CW)
#define MODE_FSKCW 2???????????????????? // FSK CW mode
#define MODE_DFCW 3????????????????????? // DFCW mode
Switch 1 off, switch 2 off: OFF
Switch 1 on, switch 2 off: QRSS
Switch 1 off, switch 2 on: FSK/CW
Switch 1 on, switch 2 on: DFCW
?
On Tue, Jun 4, 2013 at 8:53 PM, Dale <w0ir@...> wrote:
?
Can some on tell me what the switch setting should be on the QRSS Arduino Shield. I believe I should be running the board QRSS3.
Thanks Dale W0IR
?
