OK Dave, looks like there's something wrong in the area of R39 and R40. Those two resistors form a voltage divider from the 12v input and should show about 6 volts at the junction of the two. That same voltage should be on pin 5 of IC10 from where it then appears on the rest of the pins, 1,2,3,6&7. Please check those resistors and the voltage?between?them. If it is about 6 volts then check for continuity from the junction of the two resistors to pin 5 of IC10. Look at the schematic to see where this is going. Let us know what you find ... 73 .. Ron
On Thu, Mar 21, 2024 at 3:23?PM David Delongchamp <
adukhntr@...> wrote:
IC-8 pins 1,2,3,5,6, and 7 were 2.4v
IC-9 pin 1 was 4.77v, pin 2 was 4.77v, pin 3 was 4.44v, pin 5 was 2.4 v, pin 6 was 2.4v and pin 7 was 2.4v
IC-10 pin 1 was 12.58v, pin 2 was 12.58v, pin 3 was 12.58v, pin 5 was 11.16v, pin 6 was 11.34v and pin 7 was 12.58 v?
Thanks,
Dave
On Mar 21, 2024, at 1:59?PM, Ronald Taylor <wa7gil@...> wrote:
?
Ok. Then you next should check the bias voltages on the op amp ICs 8,9 and 10. With your DVM you should see about 2.5v on pins 1,2,3,5,6&7 of IC 8 and on pins 5,6&7 of IC9. You should also see about 4.8v on pins 1,2&3 of IC9 and a bit less than half the input voltage on pins 1,2,3,5,6&7 of IC10. Please verify those voltages. Thanks¡.Ron
On Thu, Mar 21, 2024 at 12:31 David Delongchamp <
adukhntr@...> wrote:
?My max BPF adjustment was 9
On Mar 21, 2024, at 12:02?PM, Ronald Taylor <wa7gil@...> wrote:
?
Hi Dave. What signal level did you see when you did the bandpass filter adjustment??
Ron
On Thu, Mar 21, 2024 at 11:18 David Delongchamp <
adukhntr@...> wrote:
I just built a QCX version 3 PCB that I purchased from QRP Labs several years ago. Upon completion of the kit I am having volume issues. With the gain turned to max I can barely hear the tone. I noticed when doing the IQ balance that I could not get higher than 3 when the directions said turn the gain control mid way and you should tune at around 9. I could only reach 3 with max gain.
Have you heard of this problem? If so what can I do to resolve this issue.
A little more info on my QCX. I am using the newest ATmega 1.09A chip. In the build I changed R41 to 150 ohm, R42 to 1.2 Kohm and C31 to 2.2 micro farad this was to improve the keying envelope.
Any input would be greatly appreciated.
Dave
W6MRD
Ronald Taylor