开云体育

I tested again this evening. The gain setting did work with SSB on VHF. I started with the same setting as it was on the recording. There I got the feedback that there is overdrive. After reducing the

I’m retired out of communications so maybe my bar is a little higher than some. I like the platform and the ability. It does not perform as good as they claim on receive so as just a receiver it

Kai, what software version are you running? Sincerely, Brian

I have to correct my last post. Audio on SSB VHF was a little distorted. I did listen to the recording again. Also I found out that the gain setting does not work on NFM. So the same could be for SSB

I will note the Email change. No need for an apology, it’s just nice to find like minded people to talk with about the Q900. We used to do stuff like this on the air? I apologize for being such a

I have been on 3 trips out of town in the past 2 weeks and haven’t been attentive here. I apologize. I hope to get back up to speed on the recent WhatsApp posts, then implement early plans yet

guohedz com ( https://www.guohedz.com/ )

That’s the symptom of to much mic sensitivity. That’s adjustable in some radio’s. Mostly commercial. What I do with ham quality radios is pad down the mic. If you hold the mic at arms length it

I have the Q900 V4 with firmware 3.4.1. The MA X9814 mic amp in my project has AGC. I did not choose this one, but it was sent to me, because the other one was not available. With the AGC there is

When I navigate to that link I get a Page Not found error.

Thank you. Problem is I can turn the mic gain all the way down and it doesn’t work. I’m trying to decide if it’s a broken radio or software issue. You just confirmed it. Your running the same

And some deadening material around the pocket for the mic. Yep did all that. I also changed out the electret mic for a Motorola that fits the hole almost perfect. The mic sens can be farther reduced

I’m not on any other sites either. Don’t have the time to waste. Hi My software is 3.4.1. Yours is 3.40? When I put in the new firm ware to fix the SSB squelch issue it srewed up my TX on SSB and

Just been on the web site of https://www.guohedz.com/DOWNLOAD but the last Firmware if 3.40? BTW I don't use WhatsApp or FaceBook & Co 73 bITON

Yes, I heard the same about drilling a hole and also maybe replacing the mic capsule. I posted it, on my new webpage for the Q900: https://dd6kw.net/microphone/ For those still interested in the

Strange... I did use SSB once on VHF with the same gain setting than on NFM (but with amplified mic and low gain). No overdrive there. Ihave V4 with 3.4.1. I would suggest to switch to the audio

Well that's my problem. It's asking for the Q900's Bluetooth pin but I don't have it. On Wed, Sep 27, 2023 at 7:53 AM, Rick N8SDR<n8sdr@...> wrote: In the FT8CN application there is an

Thank you. I’m way past that. I have firmware v3.4.1 When I loaded this to get ssb squelch I think the trouble began. Thanks for your response. Dave

Thank you for your response. I’m way past the mic. I believe it is a firmware issue. I loaded the latest firmware V3.4.1. Squelch does work! If your neighbor is running a hundred watts! Hi hi What

Yes Dave, mine per reports sounds good, but it want with the mic that comes with it. I'm using a procomm amplified mic.