开云体育

Hi: At popular request..Close file, reload file buttons have been added to main screen for next release. Close will (Duhh) close the current file. Reload will load the last loaded fil ein a session.

Steve: Pulse width. As long as it is longer than one interrupt period, it will be grabbed, if its smalled than one int period, it CAN be missed, but it would simulate your problem almost exactly.

Isak: I have found a problem in there. This would happen only in full IJ circles. I have fixed it for the next release. Thanks, Sorry for the bug.. Art www.artofcnc.ca

By pulse do you mean leading edge to leading edge, or merely the actual pulse width, if the latter that may well be the problem, I'll need to check but from memory they may be much shorter than that.

Isak: I will look deeper and get back to you. Thanks, Art www.artofcnc.ca

It is in a G2 full circuit move (G2 x0 y0 i10 j0). It seems that the CV light has no effect on the behaviour. I changed it by G61/G64 MDI command, and confirmed that the light, infact, goes on and

Steve: Even this should not matter. The only numbers that are important are "Normal SPinCount" and "Current SpinCount"... This is a good sign, the acc and dec lights mean that one cycle is slightly

No, I think you misunderstand - If commanded is say, 400 and actual is 420 it takes ages. If commanded is 400 and actual is 400 adder starts instantly and doesn't do this crazy counting to many

<hickspj467@c...> wrote: help reminder system might be added to Mach1-2 similar to the little boxes that appear under the cursor in windows apps. <snip> Dear PJH and everyone: Art will probably input

Isak: Is this in a G2,G3 move? On mine , both axis slow to a stop before correcting, then both axis accelerate. (Unless CV is used in which case it works as you describe.) Is the CV light off when

Hi Art, Maybe I didn't explain myself correctly. The problem is with the other axis (the one that dosen't need backlash correction). In a full circuit the axis which need the correction is naturally

Steve: Strange. When the spindle speed is commanded, it simply sets a frequency for the spindle axis and doesn't use it again. Let me explain the variables in use here, it may aid in troubleshooting

Art, In view of the ever growing complexity I am wondering if a 'popup' help reminder system might be added to Mach1-2 similar to the little boxes that appear under the cursor in windows apps. I

wrote: of <snip> the Yep! me too. Mach2Mill manual Fig 7.10 shows technique in Mill context. Corrections screen is handy for adding in the gage thickness. John Prentice

Windows. If made (for an Yes thanks. I would not have run Mach2 on a machine with other software and testing it in the office did not think of implications. Probably explains my previous 100 report as

Art - a few observations from some test threads: If actual spindle speed is not same as requested speed spin adder keeps going for ages before first cut starts, the bigger the discrepancy, the longer

All right Art, way to go!!!!!!!!! dg from

holder easier I've good success using a small adjustable parallel bar between the work and the tool. Get within about 3/8", adjust, measure, and set machine dro. Jerry

Hi: tell my plasma cutter to cut, is this going to be possible. Do I have bad downloads, am I downloading the wrong trial version,are there some settings to be made, What do I do. Also would like to

John: The 100 pulse rate will occur if a multi-media call is made to Windows. If you had explorer open, its possible a small multimedia call was made (for an animated icon or somethin..) this could