开云体育

Derek: Somethings lagging the GUI , thats for sure. Can't think of what though. Art www.artofcnc.ca

fast at which would it happens at 25khz and 35khz

Derek: Yes, video could be the culprit. The screen switch should be very fast at this point. Mine are pretty much instant. I can't find a problem which would explain it except a lagging GUI. Is this

it would short I seldom cut anything over .250 and mostly 10Ga. I normally do a pierce at about .190 and the next command is a G00Z.135 to drive the head into the cut. There is a certain amount

Derek Here s what you do to fix your problem, right click on "my computer" icon left click on properties, click on Advanced, click on settings, Then check on "adjust for best performance". Let me

Hi Art Well I turned off every thing I could and still have the same problem. I'm thinking it's a video problem. I noticed that changing from tab to tab on the GUI the screen changes are very

Guys, One of the plus's of using WinXP for Mach2 is that you can easily use the USB PenDrives or USB Compact FlashDrives to replace floppies, Just plug them in and WinXP knows what to do. I develop

just went to snip- Hi Art- I found that if I do a oem124 between each thc on and off things work just right. If you could tell me how to do this from a macro we wouldn't have to change the

Tom - I also forgot to mention, I also used the thc on& off to keep the torch from hunting during the pierce dwell time. On thinner metal it doesn't make much differance, but on .375 an thicker

only "listens" the separate designs time snip- Hi Tom- The reason for the thcon and off was an atempt to make g28.1 work correctly. I need the g28.1 on each pierce because the metal I use

No worries, I do not intend to require any change in code, I was just confused, because the unit was not rationalizing the DRO's when you went to move back up. All I did was add a "auto-rationalize"

use ( off

Todd: This weekend coming I think, or earlier, but I have a few things in the works so I need to finish them. Thanks, Art www.artofcnc.ca

Thanks! Once we get past this last little obstacle, the thc software and tom's control board will be working at 100%. Any Idea how long 'till the next release so I can try it out? Todd run,

Thanks Todd: I think I have it fixed. I failed to sync the engine after the THC run, so whatever the correction was, was being added to the further trajectories. It SHOULD be fix, but we'll see what

Hi- I did not know there was a way to zero the thc after a cut! I use macros in place of the m03 m05's so I can inset a zero very easily ( as long as you tell me how ). On a related subject, the

g28.1? Hi- Yes, at each pierce point I run a macro that g28.1z.1, g0z.25, m03 ( torch on) , dwells, and does a thcon(). At the end of each cut thcoff() m05, g0z1. Todd

HI TorchHeads... I have traced the THC code and as I don't use THC, I am a bit confused as to the flow. When are you turning it on and when is it turned off in your programs. I think I see the

Todd: I'm curious about something. Are you using an M5 prior to the g28.1? Art www.artofcnc.ca

I'm running a cnc router with Mach2 on a Compaq 1520, works fine. Frank Carpenter