No worries, I do not intend to require any change in code, I was just
confused, because the unit was not rationalizing the DRO's when you went to
move back up. All I did was add a "auto-rationalize" into the spindle off
routine ( which I thought was there, but I can't find it). This should not
affect anythign else,but should allow the G28.1 to work if it is called ta
any time. Though it will require a test to see if it messes anything up, on
my end it looks OK, but if it messes up I'll remove the fix the same day.
Art
www.artofcnc.ca
