开云体育

Steve: The error is from the macro threader. Part of the new code. It is saying that for some reason your macro facility is not initializing in that file. Perhaps its being called from within a

Hi Bob: Just wire the switch to the printer port, turn on the home and limit for that axis and set the pin for both to the pin you have the switch hooked to. Press the switch and both home and

Hi the g28.1 does not work correctly. If you set the z axis to anything but 0, do a zero all and try a g28.1 it does not set to 0. It seems to be related to the extrema readings being incorrect

How would I go about using the same switches for home and limit? How would I know if the switches already on my Bridgeport would be suitable? Thanks Bob

No removed them, although they were ignored by all previous versions? Any file does it, the tcollet one you have and just the two lines of simple code I posted earlier e.g. N10 G0 X10 Z30 S500 M4

Hello all around! How can I automate tool length measurement? Is it possible via some script to send mashine to some position, where digitizing switch or metall contact plate located. Then lower Z

Hello all around! How can I automate tool length measurement? Is it possible via some script to send mashine to some position, where digitizing switch or metall contact plate located. Then lower Z

Steve: Better send me that file that reverses it. Must be a variable overwrite or something. Can't repeat it here. Could it be those ' characters? Art www.artofcnc.ca

Interesting..I'll do some tests. Art www.artofcnc.ca

I had a post for mastercam9 ( I think it was a mill post from version 7 ) but I had a systemcrash and I hade to format c:\ Could someone mail it to me pls. It`ll be a great help. And if someone

It's a static problem and I now know what is happening - loading GCode is somehow inverting the state of the pin. I've just had the meter on the output of the spindle relay. It works fine in MDI mode,

Steve: I ran it several times with the scope on the output pins. No Problem. Is it a static problem on yours or intermittant? Art www.artofcnc.ca

Hello List. I was thinking about trying Mach1 or Mach2 with my sherline mill. Im currently running TCNC with a 200Mhz pentium. I have a PII 350 in the garage I can use. I was wondering if I

Here is the file G0 X10 Z10 M4 M8 G0 X0 Z0 M5 M9 -- Steve Blackmore

Steve: The strange thing there is that the LED flashing is sensed directly from the pin. The LED flashes if it is flagged as active. It isn't a setting. SO at least we know the program has flagged

Derek: Fixed for next version. Thanks, Art www.artofcnc.ca

In that case it wouldn't work as manual entries in MDI?? Works typed as MDI but not loaded as gcode. Strange for sure :( -- Steve Blackmore

Jerry: If you enter it in the DRO, that is the same as a G92, which is not saveable, if you use touchoff, you can tough to fixture or tool, and that is saveable. Thats the only

Steve: Better check thos pins, and make sure you don't have "not used" checked in the output devices config. Min emeasures properly at the pin. So its either the pin config or the output devices

Jerry: It would be high for sure. If you use 3.5 as you stated, then the distance would be something on the order of 1.5 inches I think. I'd need calculus to figure it out, and my calculus sucks.