On Thu, 14 Aug 2003 15:06:20 -0300, you wrote:
Better check thos pins, and make sure you don't have "not used" checked in
the output devices config. Min emeasures properly at the pin. So its either
the pin config or the output devices turned off that could cause that.
In that case it wouldn't work as manual entries in MDI??
Works typed as MDI but not loaded as gcode.
I get the feeling some strange shit is going on again. My zero's OK and
the spindle runs ok. I know the driver is proiper or it wouldn't run for
you...
Strange for sure :(
--
Steve Blackmore
