开云体育

Could it be here?????Ports & Pins????Turn Options ??? "Reversed Arcs in Front Post"? is it checked?? I had a problem a long time ago and I may have unchecked this box to fix

Steve, been a while since I ran mach3 but there is a setting that has to do with I J K moves if I remember its a check box in one of the settings page. Chuck

i will try this but it works with the g64/61. is there any reason that G9 is better? i do have one line moves. what is the advantage of a non modal code if the same can be done with an on and off

Note for you guys... if you simply have one move that you would like to be exact stop you can use a G9 on that line. It will stop the CV for that one move (Non Modal) . This is in the Gcode manual if

They have it and I asked them to send it to you months ago! Blah, I will tell them again to get it sent off.. The Coil winder screen is one of the screens set to be released on the new screens page

I don't like obscure risky code that others might get stuck figuring out. However the noise really bothered me? I hate hearing noise thst sounds like something is tearing itself apart. Ball screws

Hey, If it is working well for you, then that's all that matters. From: [email protected] <[email protected]> On Behalf Of spencer@... Sent: Sunday, April 4, 2021 9:48 PM To:

i do have very slow acceleration. i also found that i could just move higher than necessary and missed the edge of the hole. it is without absolute stop that it made the "grinding" noise. it was not

If the trajectory planner is combining moves that are commanded on separate lines, that is, making both moves at the same time, then something is very wrong. It sounds like Brian suspects that

*i sued the G61 and G64* and it does the job? of course i meant *used not sued*. definitely was combining moves and Brian seems to agree that the trajectory planner will do that and that the absolute

i thought i had the latest mach4 installed but who knows i am real good at mixing up versions. there was no xbox plugin in the folder in my router installation. i can download it again to be sure i

If your Mach4 is combining moves on different lines, then it is not working correctly. There's no way that a controller should ever combine 2 separate moves. I haven't had that problem, but lately

i sued the G61 and G64 and it does the job. I guess mach3 trajectory planner was different? never had that particular issue then. the xbox plugin is great once it is activated :) i tried to figure

Hey, Brian, anything? Sent: Saturday, March 27, 2021 12:22 PM To: [email protected] Subject: Re: [MachCNC] Mach4 Coil Winder Screen Hi Brian, it’s been a couple of months again-do you know

The parts counter is. In the machine now :) you also have a parts counter down counter! It is in the #vars I think off the top of my head it is #3901. You don’t have to program, just place a DRO on

The plugin is in the newest download of Mach4. But we can send you a copy so you can get just the plugin.

cycle start works and using b for the counter is just fine. no need to waste time unless you think others would like a fancy parts counter. my parts are in a sub that is run for 10000 times or

i'll try that. so there is a trajectory planner in mach4? i was going to look but forgot to see if there was an option to not combine separate moves. now that i know how to get around this i am fine

We can adjust the cv settings to make sure you have nice sharp corners. That is a function of the acceleration and the look ahead buffer depth. As for the Xbox controller I am sure we can make it

when you boot mach4, the value? in the increment field in the jog window does not necessarily have anything to do with what the selected step really is. running it up or down usually gets it right