??? "Reversed Arcs in Front Post"? is it checked?? I had a problem a long time ago and I may have unchecked this box to fix it.
Steve
On Tuesday, April 6, 2021, 3:59:29 PM CDT, chuck via groups.io <chuckels@...> wrote:
Steve,
been a while since I ran mach3 but there is a setting that has to
do with I J K moves if I remember its a check box in one of the
settings page.
Chuck
On 4/4/2021 10:06 AM, Steven DAntonio
wrote:
I just upgraded to R3.043.066 (from R2), I'm getting an error that
says "radius at end of arc differs from radius to start, block
=G02..."
I downloaded the more recent R3 from Artsoft and the? fix log
shows nothing after R3.043.62.? I can go back to R2 if need be,
but I'm hoping I don't have to. This code runs under R2.? Code
generator was RhinoCAM 2017.? I'm running under win XP SP 3 since
my computers with an LPT1 port with not support anything higher.
I'm seeing this error with every piece of code I have tested so
far, all of which ran under R2 without issues.
Here is a snippet of the code (bold line is the one that crashes)
