开云体育

two question. i did get it to work with a simple test program putting all the code for the part in a sub and calling it a number of times. once i realized that the B axis was not enabled and i enabled

great because i can't seem to get any screen editor to work. tried running in virtual box. i was ready to get the scale out which i might do anyway. i am ready to start making parts so i will check

If you use the b axis you can see the count on the diagnostics screen. No need to add the DRO to a screen then. Martin

i think i just confirmed that none of the screen editors work on win 10 64 bit. so if i want to edit a screen, should i just try doing it with an xp computer? or maybe try it in virtual xp? my only

that looks like an easy solution. i am using the A axis. i should post a video some day. the machine is pretty neat but still full of bugs after just 7 years working on it. i would like to add a B

i was going to add an electrical counter but that would of course take time to get right and not just destroy switchs. could use a hall effect switch. i had a nice little counter on my punch press

"I just thought of something that might work but it will not allow for decrementing. I could keep all the bad parts until I finish the job and then count them separately." What about two bins one

It sounds like the parts you are talking about are not using the 4th axis A. If you set A to zero at the start of your loop you can have a counter that increases by 1 at the end of the loop and moves

Spencer, Interesting project, would you need to have a counter for each part type you made, or just the one currently on the cancel? The latter is easier, but you would still need to remember to reset

G-Code has a range of variables (#500-#1000 IIRC) where you can store stuff like that. Tony Sent: Saturday, 15 February 2020 3:18 AM To: [email protected] Subject: [MachCNC] parts counter

I looked in the forums and did find "answers" to this but nothing that did not seem like a lot of work and beyond my current understanding of how mach 3 works and how to hack it. So, the question is,

Edit "new program.tap". It's in the Gcode folder. Martin

It shows up when I first add it but at some time after it disappears. I have tried adding photos to this group but could not find? way. It is an image of the wiring details of a universal pendant

I want to edit the actual output. the license is already established. each wizard only lifts Z up above the part, there's no provision to retract Z all the way up, no cancellation of TLO, no provision

Martin, Looks like the attachment did not come through. Dale

Have you considered a wireless hand held mini keyboard as a pendant. They are very cheap and I have seen a number of people using them as remote controllers for CNC machines. Search for "Rii i8" on

Do you just want a licence password to use them as that is different from editing them and is, as pointed out, not good for the commercial supplier. To some extent wizards are parameterised Gcode

thanks 10-4, over :) hugs ? Best regards, Spencer Chase 67550 Bell Springs Rd. Garberville, CA 95542 Postal service only. Laytonville, CA 95454 UPS

??? ??? gotchya ??? ??? animal

also why do you think i think i am better than anyone else on the list? i have mainly asked questions for the experts to answer and rarely have answers. i am trying to hack my way through all of this