开云体育

Jeff: Hmm, I could understand if it was reverse of that, but for MAch2 to read 23 then 25 is a bit strange... Art www.artofcnc.ca

Art, My point was that there is some sort of interaction between Mach2 and the OCX. I was stating that before I ran the ocx my frequecy as measured by Mach2 was 23KHZ. After running the OCX the

Scott: Is your program written with G1 moves? OverRide will not override a G0 move. Thanks, Art www.artofcnc.ca

Hi,i am having a problem with the feedrate overide in mach 2,seems as something is holding it back,when i ajust the override nothing changes,can anyone give me quick idea where to correct this,I`ve

up. No problem. As I said earlier, the problem is not the user, simply a matter of complexity. I fully understand.. Art www.artofcnc.ca

will, when offset, this Thats the problem. I kind of figured it was somthing I was screwing up. Thanks Art

Steve: switched on momentarily and then off Which motor, you mean the spindle motor???? The motor should be running and up to speed when the G32 is called. Or do you mean the Z motor starts and then

Derek: Do you have a G49 in your program? If you do, then "runFromHere" will, when executing the program from the begginning, will turn off the offset, this will mean you are NOT offset the way you

500rpm is set value, and motor never moves more than 2 or 3 rpm off this under normal use No missing pulses I can see?

Hi Art When ever I use the run from here command I end up burying my bit into the work. Here's the deal. I have a model that is in the +Z envelope. I'm using a G43 tool offset. When the preparatory

Hi All: It has become quite apparent that I could go to RC34572 if we continue as we have been. So, in order to clear things up and to make life easier for not only John (The Doc wizard) but for

500rpm is set value, and motor never moves more than 2 or 3 rpm off this under normal use No missing pulses I can see?

Current Spin Count 4813 4696 5216 Spin adder 1552 1751 1578 These particular values look pretty good. Remember the numbers are multiples of 40us, so a Spin countof 2937 is .117 seconds per rev and

They jump about all over the place, on three runs at the end I get different values each time - note these are when file has finished Which it seems to be doing most of the time now, but not always!

Luis, When I looked a month or so back on the Mecsoft download posts screen the very last post is for Mach1. I don't know how it got there but its there. Works OK for me. Roger

Jeff: The ocx test is a very bad way to measure your pulse frequency. It uses a method where it says to the system, start counting, wait one second and then stop counting. What is the total? The

Art, Could you tell me why my pulse frequency went from 23Khz to 25Khz after running the OCX test? For weeks my frequency was a rock solid 25Khz (plus some small amout) then I installed RC11 and it

Tim: Good point. Perhaps a Ref button on tha main screen, this would zero a machine that has no home switches.... As to removing Jog on the first screen, Tried that, went there, got tons of abuse and

Isak: The results you describe are exactly what will happen if CV mode is on, was it on for this test, and if you turn it off does the same thing happen? Thanks, Art

Thanks Bob. I will try Fanuc. wrote: create a http://docs