Is it possible that you have the Kernel speed HZ set to high?
toggle quoted message
Show quoted text
-----Original Message-----
From:
[email protected] [mailto:
[email protected]] On Behalf Of spencer@...
Sent: Friday, March 26, 2021 5:17 PM
To:
[email protected]Subject: Re: [MachCNC] help with customizations ?
so why are we the only lucky ones. i have broken two $20 new router bits so far.
On 3/26/2021 1:24 PM, Jim Guthrie wrote:
On Fri, 26 Mar 2021 11:59:56 -0700, you wrote:
the most annoying thing is that when jogging with the keyboard i use
small steps with a single click of the hotkey for an axis and use
shift to do a fast move. not very often but occasionally the machine
just runs totallyout of control in the jog direction and breaks a
carbide bit. i have changed keyboards and am pretty sure it is not a
sticky key. will try yet another one.
I have the same problem since I fitted ESS a month or two ago to my
Mach3 setup. It happens when I use the high speed jog (Shift Up,Down, Left,
Right,PgUp, PgDn). So far it has only happened on the X axis. I thought
it might be something like a buffer over-run since it only seemed to happen
when I was doing a longish jog. I reduced the repeat key speed on my
keyboard to the lowest setting but it still happens on occasion.
Thankfully so far no damage has been done since EStop and the limit
switches still operate and it normally happens when I'm setting things up when the cutter
is raised above the work. I've dug around a bit on the Internet to see if
someone else has the same problem, but no luck so far.
Jim.
--
Best regards, Spencer Chase
67550 Bell Springs Rd.
Garberville, CA 95542 Postal service only.
Laytonville, CA 95454 UPS only.
Spencer@...
(425) 791-0309
--
This email has been checked for viruses by Avast antivirus software.
