开云体育

Out of curiosity: what does: dmesg | grep ttyAMA0 show? If it has console=ttyAMA0,115200 so far so good Then what does cat /etc/default/gpsd show? You may have to edit it to look like: ----- # Default

DATA-U is right.

Hello Brian, Sad to hear about the bands being in poor condition.? I'll see if I can focus on 30m and get a connection. I'm very aware of the weird settings the FT-891 has to have.? I will

Jason, I'm seeing similar results with GPS dongle and Conky.? Dongle is the U-Blox one that most everyone else has from Amazon. After a fresh boot/reboot, Gridsquare is blank.? Running the bash

It was a pretty rough day for the bands. It took me a while to get a good Winlink VARA connection (and VARA works better than ARDOP in poor conditions). I ended up connecting with a station on 30m

KM4ACK and KD9FRQ I'm having a very similar issue.? All connections for ARDOP fail to connect with a "Connect timeout".? Auto Pat has gone through all RMS gateways with out connecting to any of

Kevin is correct. You will either need a GPS or a RTC if not connected to the internet because the Pi doesn't have a RTC built in. A cheap/easy way is to share the GPS from your mobile phone

I’m having a nightmare of a time getting my mobile linked to work and build a pi. I followed both of KM4ACK‘s videos for getting it to work but no matter what I do it is errors out when I try to

That is odd. I'm assuming you tried all the chromium tricks like clearing the cache or reinstall? I'm no expert but that has helped me out once or twice.

If you are not connecting to the network, you could set up an ntpd daemon (like the gpsd daemon) and have it pull the time from your GPS. (If you are using one. Another option is an inexpensive RTC

Wanted to chime in here with a bit of experience. I had successfully installed the forms on three of my Pi's. Then I had a Patron contact me that was having issues. After speaking with him via email

Jason, I shut down the pi last evening to check if the time/date would update at restart. No such luck. Conky shows last evening at shutdown time. Suggestions? Richard KI5EVJ

I was trying the same thing. I wish there was a command line version for config and then Vnc for the usage or even things like digipeater/igate to work w/o the GUI completely. I config all my pis

ssh to pi cd /boot sudo nano config.txt then make these changes. ?Then save and exit the editor. # uncomment if hdmi display is not detected and composite is being output hdmi_force_hotplug=1 #

Good Morning guys, I have finally ventured into a Pi4 to use with my tablet on camping trips and anytime I can get away. I downloaded the OS from github as Jason link provided, I got the Pi4 up and

Thanks. Checked the pi config on the main menu. Time zone was off by one -EDT vs CDT. Still off by almost 35 hours. Found the ‘sudo date -s …’ command. That fixed it after reboot. Not sure how

If you saw my network you would understand. ?

I see that you have experienced the loss of a Pi on the network. hihi! Been there, done that. ? -- 73, de KM4ACK YouTube ( https://youtube.com/km4ack ) | Tip Jar ( https://www.paypal.me/km4ack )

Conky gets the current local time from your Pi system clock. Double check that the time zone is set correct on the Pi. -- 73, de KM4ACK YouTube ( https://youtube.com/km4ack ) | Tip Jar (

On the Pi there are two commands to run: sudo systemctl start pat@USERNAME sudo systemctl enable pat@USERNAME Be sure to replace USERNAME with your actual username on the laptop. If this doesn't work,