开云体育

Don't know what to tell you Bill, but it's working fine here under the latest Buster and Build-A-Pi 3.1.0 [image: image.png] Jerry [email protected]> wrote:

Having sames issue so I went looking into why; Here's what I found : https://repology.org/project/flamp/versions looks like 2.2.07 is not available yet for PI os Buster (based on Debian Linux). So

I have same problem here. Only difference in setting is mine use 5000 instead of 8080 What i also noted is that rigcontrol in conkey does not go green - In older version it used to go green but did

FLRIG works fine with FLDIGI and WSJT-x ARDOP and PAT does not change the radio frequency nor activate the PTT when I select "Action/Connect" on the PAT menu and then select an RMS from the list. The

You could try to turn it on manually from the raspi-config menu using the command sudo raspi-config I know you can setup your wifi options in that menu. Can you see the wifi icon on your desktop?

I found a workaround, and have submitted it to Jason for his consideration. Below is that suggestion: *Hi Jason -* *Continued with the past problem in that FLAMP always* *indicated 'NEED UPDATE', but

I started to play around with the new patch feature with BAP 3.1 I did find that if you selected multiple patches, it only installs the first patch. The other patches are not installed, so I had to

I'm trying to install build-a-pi on my raspberry pi 4 8gb, install the program go thru the setup script after the reboot i can not connect to internet. i can not access my wifi or ethernet get "no

Hi, I’m new to the raspberry 4 and build a pi. I have most everything working bit grid square on Conky. The GPS works off the IC-705 only by itself, this was confirmed by gpsd check. If it’s

I just ran command "arecord -l" and it didn't list anything. Then it hit me to plug a device in, so I grabbed a pair of USB headsets and re-ran that command and now it shows it. I'm building this Pi

Hi Steve Check the pi for what you wanted to install to make sure all finished. I saw where mine finished but Fldigi wasn't and maybe some others didn't install. Just to be sure. Marty

Marty, Thanks for your reply. It finally completed the build. Nearly 18 hours! 73, Steve

Hi Steve I think with the Pi3 you have run into the run out of swap space issue. On Pi's with both 3 and 4 with 4GB or less or maybe it is less than 4GB of RAM you will see this behavior when

Updated to the new 3.1.0 and applied the FLMSG patch successfully. I was hoping that it would fix whatever was wrong with the error when triyng to update FLMSG also. This is the output I get in the

Run this command: *arecord -l* and it should return something like this **** List of CAPTURE Hardware Devices **** card 2: CODEC [USB Audio CODEC], device 0: USB Audio [USB Audio] Subdevices: 0/1

I did not mean to add that #antenna and I can't see a way to delete it. Perhaps a Mod can pull that off.

Good information and I’ll be checking my setup. Thanks

#direwolf I'm new to Pi and Linux and working on my first Build a Pi. I followed Jason's APRS video and everything seams installed correctly but I'm getting a Dire Wolf failure and it shuts down

Over 8 hrs into this now, still blank screen. I would like to get this running before we head to Alaska on Wednesday, simply for FT8 (WSJT-X). Should I just omit the other packages and try another

After a few minutes involving some transmitting on just sitting there receiving? If transmitting, more than likely you have an RF common mode current problem. Do you have a dummy load. If so, try