开云体育

I am very pleased to report that the install went fully through and completed.? Thanks Jason for sticking in there with me. Kevin/NB7O

That was it!.? Getting further into the install.? I am certain that I tried the tab and arrow keys before.? I also should have picked up on this because the same behavior is exhibited in

I also have the Dockerpi that Jason recommended. No rfi, super quiet fan and my pi runs several degrees C cooler

I am formatting and writing buster to a new sd card.? I will give that a try again.? I tried tab, space, esc. all to no avail b4.? crossing fingers this time. kevin/NB7O

I use these things which are called UBEC's by the radio control people, for some reason. They're very quiet. The circuit board is completely shielded, and the output has a toroid already installed.

You need to use the tab key to select ok. Then enter key to "push the button" -- 73, de KM4ACK YouTube ( https://youtube.com/km4ack ) | Tip Jar ( https://www.paypal.me/km4ack ) Twitter (

Please post to the issue tracker so I can look into it for a future release. https://github.com/km4ack/pi-build -- 73, de KM4ACK YouTube ( https://youtube.com/km4ack ) | Tip Jar (

You will need to start things manually in terminal until you get it figured out. Then you should be able to move to Pat Menu to make things easier going forward. -- 73, de KM4ACK YouTube (

In pat menu settings, set rig control to no. Then do not enter a frequency in the frequency box of the pat connect screen. Then pat will not attempt rig control. -- 73, de KM4ACK YouTube (

I tried again and here is where the script stops.? I am currently downloading the May 2020 release of Buster.? I had been using the Feb 2020 release of Buster.? i will do update and upgrade and

Steve, i'm not sure, but what you may be seeing is the default time setting for the Hotspot to "check" status of available Wifi SSIDs it is aware of.? I'm just guessing here.? If you haven't already

Haven't installed/tested it yet, but I followed Jason's link to the power board on Amazon that he uses, haven't asked about birdies, but trust his judgement *and* he has shared videos operating with

Hi Mark, My shack is run by a 500W off grid solar setup and I also live in a 12v world. I stopped by my local dollar tree and picked up several of their cigarette lighter to 5v usb widgets. Ripped

This is a WiFi Hotspot... "Not" a Radio Hotspot Link: What is A WiFi HotSpot ( http://tiny.cc/What_is_WiFi_Hotspot )

I have an audio issue with a new install of 'Build a Pi V3’. I did the install a few days ago and the install worked fine. I was watching the YouTube videos and following along to review the various

I am running headless with Build-a-Pi.? Everything is working fine except the Hotspot seems to restart every 5 minutes.? I've looked for the Hotspot signal using several different devices.

The Pi Hat that Jason has recommended works nicely. 73s, Ed, KD9FRQ

well I got up this morning, wandered into the radio room to see how the pi-build and found the same stopping point with a message about Xastir and AX.25.? Xastir does not load, conky does not

I got some of the Buck Converters with USB - https://amzn.to/357prG6 (

Thanks for the VooDoo that you do Jason, and all the other contributors. -- 73 VE6AJE