开云体育

I was removed from the group for some odd reason. But I think I am back. Walt Cates, WD0GOF https://wd0gof.com/Hallicrafters A majority of acceptance is not proof of

Walt, for those of us that have a hard time seeing those little screens, is there an output for a signal display on a larger screen? From: [email protected]

Bill, Yes, it can. It has eliminated several test instruments from my bench. It is a spectrum analyzer, RF signal generator (cw, am, fm), sweep generator and frequency generator. You can sweep filters

Walt, congrats on the calibration. Question since I'm new to these devices, can a TinySA, inject a signal into a tuned circuit on 2 meters to find out where its resonant ? IOW, I have built a 2

That is indeed a good start for the New Year. Am now back on track with the SR-150+ here and ready to restart the VFO and RIT/CAL checkout. With just some preliminary testing it appears the receiver

Life is good. Have an SR-500 on the work bench. I turned it on and set the dial to 7.175. Set the AF and RF gain to max and let it warm up. In the meantime, I unboxed my new TinySA ultra. Ureka, it

Fraser I am glad I could help. Enjoy the now aligned SX-122 receiver. 73 Dick W7KDL

Thanks to some timely and useful information from Dick, W7KDL, I did indeed have the Bandspread set wrong. ?I had the bandspread dial zeroed with the tuning cap at maximum instead of minimum. ?Once

Hello all, not about this topic, but earlier today I could not find what I thought I had just seen from Bill [owner] and went on-line and found every recent post to be LOCKED. Not so long after

Fraser: SX-122 I attached the 2 pix, But I am not sure that they went out with the text. If you did not get the pix, contact me and I will send them a different way. Dick W7KDL

W3UTD Fraser: SX-122 receiver. The following are 2 pix of the Bandspread at one end and at the other end of variable capacitor range. Any questions, please email or call me. W7KDL Dick

Making good strides with mine, working some issues with alignment.? I'm wanting to know if the situation with the bandspread below is normal, or if I'm doing something wrong: Bandspread Set, and

Well, it doesn't sound bad Jerry, but I do hear the pull of the CW note. I presume you've tried different a oscillator tube? Have you looked at the output at the vfo on a scope? GL es 73 Steve w8tow

I looked into the Progrock2 for another project and you have to almost double that $18 for international shipping from Turkey. I don't think they have a domestic (US) shipping source. Russ N3CO

REF; progrock2 device: For $18 it is worth investigating Walt Cates, WD0GOF https://wd0gof.com/Hallicrafters A majority of acceptance is not proof of

Walt, I have the same issue with my SR-2000, yet for me it is the USB carrier crystal. After receiving a couple of USB replacement crystals and finding that they too were too far out of spec, I

Thank Halden. I ordered from AF4K.... 73 Dave wa3gin [email protected]> wrote:

Hi Dave To get you into the ballpark, you could try an 11.52 MHz crystal from Mouser or Digikey.? It might oscillate at its 3rd harmonic.? Also, try Netty Electronics.

Possibly alignment of 1055-KC Third Conversion Oscillator or V10 weak. Von: [email protected] <[email protected]> Im Auftrag von Norm Drechsel Gesendet: Freitag, 20.

Hi folks, Does anyone have a source for crystals for the SR - 150? *As seen in the recent picture the xtal in the first 10-meter band slot is wrong. It is a 3.5MHz xtal and should be