开云体育

Your printing on white took me back to old school method.? Pasted the logo into a black square in MS Paint and used the paintbrush & pencil to fill in the white. Then printed onto plain white copy

No, a standard inkjet from Cannon.? I also have white decal paper but it's not transparent, the white background showing in the circle and letter voids looks awful. I only run into this issue with

Dan - I remember buying white decal paper several years ago.? Are you using an Alps MD printer? 73, -- Justin B. KI5GKD

Finished the S-14 restore this weekend, it'll join the 5-T in the collection. I need to source the gold Hallicrafters logo each originally had in the upper right corner. My standard printer makes a

Hi, Re: HA-1 keyer output stuck key-down I would first unplug the octal-based relay to see if that clears the problem. You may have a relay whose output contacts have become welded closed. Then,

Bill - here you go (these were the gray knurled plastic knobs used in the SX-110/111 and HT-37 rigs from the early-mid 60s):

Hello Dave ! I hope the picture below comes through OK. I’m looking for three of the type of small knob you see two of in the center of the picture of the four knobs below. Might you have some of

I have some of the grey knobs. Dave KB6MBC

I saw some of these knobs for sale on eBay just yesterday while searching for some correct knobs for my HT-46 (which I could not find). Mike/ K5MGR ___________________________ Mike Langner 929 Alameda

Got the TO setup with my TS-530S this morning and made some contacts on 30 meters.? Took a while to get used to it being non-iambic but I got to where my fist wasn't too bad lol.? It seems to work

I had to replace practically all the resistors on my HA-1. The circuit for the dash`s is created by double triggering the dots. The resistance values ??are very important here. It is also

May be the same problem I am having. Have not found out yet what is causing it. -- Richard Knoppow Los Angeles WB6KBL SKCC 19998

For those in need of extender / risers boards I am here to help. Please make contact directly. John WA1ESO (AT) JUNO (DOT) COM

Thanks … this is useful. The key paddles are not the issue as the same thing happens with the plug completely disengaged from the Jack. It may be a simple as a couple of leads touching … very

As suggested, make sure the connector or paddle is not shorted but my HA-1 has developed the same problem. I think its a defective capacitor or resistor. Have been lifting and testing parts. When I

It occurred to me after posting my piece that "keyer" also applies to the part of a transmitter used to change the output to send code. It can be some electronic device or a relay, can change bias or

Sounds like your paddles are not wired right. Quick check, pull the plug. If it stops then you have either a short in the plug or plug not wired correctly. Not uncommon to have things pushed together

Powered up the HA1. All seems to function except it appears to be stuck in the key down position … sidetone continuous and contact on output mercury relay are closed. It’s as if HOLD was selected

OK – Be Happy - Mike B. Feher, N4FS 89 Arnold Blvd. Howell NJ 07731 908-902-3831 Sent: Thursday, September 5, 2024 11:32 AM To: [email protected]; [email protected] Subject:

Not according to the manufacturer or the dealer selling the most popular semi-automatic bug - it is a KEY:: ?? Vibroplex Original Bug Keys ORIGINAL-D ????5 out of 5 stars?( 5 ) ? Part