开云体育

Hello to the group. I have an 8563E spectrum analyser with what I strongly suspect is a fault on the A15 board. There is no calibration output signal on the front panel. The analyser shows multiple

I want to make some measurements in WR90 waveguide on a VNA. But since it for amateur use (3 cm band) I can't justify buying an HP/Agilent X11644A calibration kit - even a used one. However, I believe

Hi Cliff, to verify easily your YIG oscillator , there is an auxiliary output at the rear of the plug-in if you do have a power meter , you can check the operating YIG connecting it to the Aux output

Hello, I have an HP 54001A 1GHz probe that I want to use as a general purpose probe. It's specifically designed to operate with the HP 54001A/D digitizing oscilloscope. I intend to build a suitable

Hello to all, I am looking to purchase a reasonably priced recent calibration HP 8591 analyzer , or other up to 2 GHz. Any leads or recommendations would be appreciated. e-mail response preferrd I

Hi there Ken, You're welcome - that's why we have this group...! Best regards, Ron Wilkinson mi-Biz Systems Pty Ltd Perth - Western Australia ==== k8kwh wrote:

Thanks, Ron! POWERON saves all settings everywhere....RF GEN, RF ANAL, everything in the unit at the time of shut down. Exactly what I needed. Thanks, all, and thanks again to my new friend from Down

Ok then if it is really E050 then it supposedly a front panel push button error on the 83592A, If two errors occur typically (most) HP gear defaults to displaying the first error encountered, not some

Hi Dave, I have downloaded the Service manual from the Agilent site. I agree that there is scope for mis-reading the code.... But it really is E050, (or possibly E0B0). I did wonder, what happens if

E080 ( actually E050 -E090 are all) Plug-in error code I don't have an 83592A manual to refer to and the 83592B manual does not appear at first glance to have the E080 error code ( unless that is a

Tim, You should be able to patch your bus interface cable (probably a 85662-60094). HSWP/OUT is pin 44 on the 50-pin, D-sub end of the cable. Just splice a wire for the SMA connection to the wire

I have a non working Hp8350B Sweeper, with 83592A (10MHz-20GHz)Plug-in. On Power-up it occasionally displays error message E080. (now seems to be permanent). I would like to know what this means and

Ooops sorry for the bandwidth that was supposed to just to Glenn :-)

Glenn If your still interested I will send you a trial set to take a whack at Dave ArtekManuals

Bill , ??????? thanks for that information. I guess there is a very small chance the original cable adapter pair, might not work with a newer instrument, but it seems pretty unlikely based on

Greetings all, Try saving the state as "POWERON", then restart... Regards, Ron Wilkinson mi-Biz Systems Pty Ltd Perth - Western Australia ==== Artekmedia wrote:

I toured a factory a few years ago and was surprised to see several Heathkit counters, SM-2420's, still being used in their repair centers. I made a comment to one of the executives and he said they

Max, I grew up on Heathkit and built a few kits before they went under the first time. I recall building a HW101 HF transceiver, 20 MHz scope, HW2016 2-meter transceiver (my first fully synthesized

Thank you Joe. I'll give it some thought. I do have a well equipped lab but my frequency counter is a Heathkit. I'm retired so I have lots of time and experience. As the price of HP gear has come down

Does anyone know anything about how to talk to these boxes? They are very nice receivers with built-in GPS. Comms are via RS232, but have no data on what commands are. I've been told that the FPGA