开云体育

Hi, This ?has been on the backburner for a few weeks since it got frustrating and figured this is the correct place to ask. Does anyone here remember how windows 2000 boot partitions work in

On the top left of the 8559A plugin there is a small circuit card that makes contact with 2 fingers on the top guide rail on the 853A. Remove the top-sides cover of the 853A so that you can see the

Thanks guys. I thought about dirty words, but went for a sweet message to my wife instead.

Thanks, I checked that and just for grins, I flipped the DIP switch to select it, and in the Talker Only position neither meter accepts commands.

Any chance that one might be set as a Talker only? I'm not familiar with that specific meter, but sometimes there's a setting, either a DIP switch or something from the front panel, that makes it

Working on writing a communications library to control my HP3456A DMMs. One of the meters that I have responds to instructions to read and write just fine. The other meter will read the correct value

You can find it here: https://www.ebay.com/itm/156895637542

Well done Matthew! "This is such a cool piece of history and I am honored to have helped preserve it." Agreed! Congrats. Renaud

I think I would spend most of my time seeing what kind of crude and tasteless words I could make on that thing. ;) Nice find indeed!

Hi Dave, I planned on doing this. I keep the intensity down, I just increased it for the photos because my phone needed it. Thanks Arnaud.

HI. Personally, the first thing I'd do with that, is all the covers off and clean it.? While doing that you may find something simple like a damaged or disconnected internal connector. Also, best

Thanks for checking anyway! Does anyone else know where I can find this info, or have a copy? Jared

I just wanted to provide a quick update on this. The first NOS switch I got off of eBay was oxidized inside and didn't work right either. I found a "used" one in Canada, also off of eBay, and I

Yes I am aware of the switches issues. They're gone but I have enough to make one working and good looking unit. Just do describe the situation more precisely: - With no module, I get a single dot on

I am, by consequence of the equipment available, a very long time user of Tektronix oscilloscopes. I have several here in my home lab (thank you, Jim Williams). But at my first job as a technician in

Hello Alwyn, You make some very good points. Decades ago a good friend of mine went to the Gathersburg Maryland USA HP office off of Shady Grove Road to review and look at the then new HP1740A 100MHz

Agilent mentions? part? 0590-1251? as ... 15/32-32 hex nut, in several manuals. The tool they say to use is a "socket wrench and 9/16-inch deep socket"

I had exactly the same problem on my 70004A, using the same procedure to fix the issue i had to replace one defective D41464C (in my case U103). Don't loose time to look the VRAM section because their

Hi all, Sphere Electronics has yet more HPIB cables going cheap. https://www.sphere.bc.ca/recently-added/ Regards, Waz

Sounds good. Thanks for the 83752A tip and additional information! I have some 3047A information, 8642 On-Site Service Manual, 3561A Service Manual two volumes, that I will see about