开云体育

Does anyone have any CPU Board data. I have the service manual such as it is. I'm having a problem with the analog bus voltages coming up as out of range when I measure them within

HI guys I have a HP 8558b with a hp182t m/f I have two problems one is the display on the 182t shows a sharp dip in the middle of the screen wether the 8558b is plugin or not . the second is the 8558b

From what I have heard (so cant confirm) is that when the progs are copied from the orig disks there is a bit set on the orig and the copy of the program that allows only one copy. If the orig

Lloyd I'll gladly contribute some dead A/D boards to the reverse engineering cause. This board is probably the single largest failure card in the 54111D family. People will buy up 54111D carcasses

I am interested in manufacturing replacement A/D boards for the HP 54111D. I saw comments on the unavailability of schematics. Does anyone have further info on contacting Agilent or reverse

<mike@a...> wrote: my They Probes leads are passive. You just need suitable 0.154" conector blo

hp_agilent_equipment@... writes: Gentlemen: You might try an MTA-156 IDC receptacle used for wire-to-board interconnection. They are available for about $1.00 each. The 12 position

Yes. That's it. But... The HP1631D is a different (older) unit than I thought. So, my advice isn't as applicable. Looking at the pictures in the two auctions below, the probe tips

Hello Mike, you sells. most the you Do you mean this pdf? http://cp.literature.agilent.com/litweb/pdf/5968-4632E.pdf The logic analyzer has the PODs. and they contain - as far as I can see -

Keep an eye out on ebay. Every now and then, someone puts up a set of grabbers (just grabbers without the pods) and they tend to go for about $20 per set of 20 grabbers. Of (just in case I

My usual plea.......anybody have a list of 3586c commands? (I never get manuals with my stuff)... Thanks to all who replied regarding the peeling meters and all.. 73 Tom

I have a 1631D with all the Pods, but missing grabbers... And finding affordable kits has been impossible... Is it possible to make grabbers myself? I thought the Pods have MTA 156 connectors.. And

Hi All I have obtained some software for the 4952A protocol Analyser. These have been copied using the LIFUTIL utility. However wheras the data files work fine the applications (things like a VT100

I have a manual for 204C. If that would do, I can send you schematic; manual is too many pages to scan. Even better, the whole manual is on BAMA site ( http://bama.sbc.edu/hp.htm ); that site has

The original message was received at Tue, 2 Dec 2003 22:35:50 0800 ----- The following addresses had permanent fatal errors ----- <greg_werstiuk@...> ----- Transcript of session follows

Hello, Did You Try Bama. They Have A Few HP Manuals. http://bama.sbc.edu/ Greyhawk

Does anyone have an e-mailable manual (or at least a schematic) for an HP 204B Oscillator. It would be sincerely appreciated. Tom Leedy Clarksburg, MD

Hi Sam, I have the PDF manual for a 428B model if that will help. Regards, Jim --- sreaves22655 <sreaves@...> wrote: __________________________________ Do you Yahoo!? Free Pop-Up

Anyone have an emailable copy of the HP 428A? Sam W3OHM

Have you asked sphere? http://www.sphere.bc.ca/test/hp-parts/hpparts7.html he hasn't those knobs in his list yet, but to ask him is always wise Jorgen dj0ud