--- In hp_agilent_equipment@..., Michael Lohmeyer
<mike@a...> wrote:
At 3:56 AM +0000 12/12/03, MauriceS_65 wrote:
Do you mean this pdf?
Yes. That's it. But...
The logic analyzer has the PODs. and they contain - as far as I can
see - 11 pin 0.156" Connectors...
I can get the grabbers, but I have not seen any sets for this
particular model...
The HP1631D is a different (older) unit than I thought. So,
my
advice isn't as applicable. Looking at the pictures in the two
auctions below, the probe tips aren't just simple wires. Note the
wires all go into a plastic block, which then attaches to the HP
10271A and HP 10272A boxes. You need these wires ends, right?
They
probably have some kind of RC network in them, like the pods
described in the PDF file above.
Probes leads are passive. You just need suitable 0.154" conector
block, wire and then connection to grabber.
I have just sold my 1630D on Ebay you can wee the home made leads in
the picture. Grabbers came from 1650 series and are relativly easy to
obtain.
ViewItem&item=2576377602&category=40004&rd=1
Richard
ViewItem&item=2581080559&category=25395
ViewItem&item=2580220769&category=25395
You might try contacting vendors that rent or sell used
equipment. These units are old enough that they may have a set
laying around which they are willing to sell for cheap.
Good luck. Sorry I wasn't much help.
Mike
--
----------------
Michael Lohmeyer
mike@a...
