At 3:56 AM +0000 12/12/03, MauriceS_65 wrote:
Do you mean this pdf?
Yes. That's it. But...
The logic analyzer has the PODs. and they contain - as far as I can
see - 11 pin 0.156" Connectors...
I can get the grabbers, but I have not seen any sets for this
particular model...
The HP1631D is a different (older) unit than I thought. So, my advice isn't as applicable. Looking at the pictures in the two auctions below, the probe tips aren't just simple wires. Note the wires all go into a plastic block, which then attaches to the HP 10271A and HP 10272A boxes. You need these wires ends, right? They probably have some kind of RC network in them, like the pods described in the PDF file above.
You might try contacting vendors that rent or sell used equipment. These units are old enough that they may have a set laying around which they are willing to sell for cheap.
Good luck. Sorry I wasn't much help.
Mike
--
----------------
Michael Lohmeyer
mike@...
