开云体育

Hi, I bought a HP 1141A RF Differential probe on eBay. It did not come with a power supply. The power connector looks like a 8 pin DIN connector. This would seem to me to indicate that the power

Now that all these CLIP's start to appear, was there ever anything on the 8753A? Dean

Hi I have the clip for 8920a in pdf.Do believe it was taken from agilent manual section,but were removed . Can make a copy if needed. Regards Hardy

Hi Don, If you attached the 410C calibration adjustments [OP-Amp] to the Yahoo group It will not pass to us. Could you mail it to this; jos.raven@... 73's Jos PA0amx

Hi Mike G6NCE, I also been looking for the HP415E manuals, would it be possible to email them to me at garybeech@... thank you 73's Gary VK2KYP ________________________________ From:

wrote: supplement I ordered this from Dave and just want to confirm that the quality is excellent. It includes all the schematics except the input pods. Good work Dave! Dean

J Forster wrote: The HP cables are matched for length. It isn't all that critical in actual practice. I use a set of RG313 jumper cables I got from The RF Connection. They came from some surplus

"rovmkr" <bunge@...> wrote: Thanks Bruce, the Digi Key states the inner connection is soldered and the shield can be soldered or crimped. Since the hardest to solder is the center then it should

Here`s the info, guys. I have both the op-amp, and photochopper version manuals, so if you want more info, it`s there. My 410C uses the photochopper, but it works well, so I haven`t modified that part

Keep in mind that you will probably also need to invest in the correct crimping tools, since the contacts for the mixed-type D-subs are considered mil-spec. Such tooling, though a bit pricey if bought

I tried Rohde & Schwarz for schematics for this VHF/UHF test receiver, but they replied that they "stopped the repair of this equipment 10 years ago", and that "repair for the ESU 2 is no longer

Hi Andreas, Email me off group, please, I have the information you want. Cheers,........................................................Don C.

Hi, I am not familiar with the exact part in question, but very often, spectrum analyzer mixers are of the double balanced diode type (DBM). When working correctly, a DBM provides at least 20dB of

Erik, most probably an open capacitor, or a defective connector. Try skipping all the components before the mixer, and injec

Hello , While the spectrumanalyzer pro-and contra's are actual on this group, may be someone can help with this: My 70904A RF module (HP70100 analyzer) works perfectly from 10 MHz to 2.9 GHz , however

Hi all, I recently aquired a 410C, after difficulties to calibrate the AC Range properly (and a very hot Probe) I discovered a 2-01C tube in my Multimeter - running on 6.2 Volts. Funny enough my 410C

Good day, * REPLY SEPARATOR *

wrote: Thanks Dean, I found connectors at DigiKey by searching 24w7 - this will take you to the page where the body and inserts are. I am in the process of selecting the correct coax PINs (not

im looking for a replacement translator module for an hp 86220a plug in as used with an 8620 a or c sweeper or possibly a junk plugin thsat might have a good module the module is a rectangular metal

Just received from Ebay a 8170a as is that is missing a cable between Video board and output board. I found a ribbon cable with plugs that fit however need help with verifying correct pin out between