开云体育

Fellow techies in all groups (that I subscribe to), I just found the following on Usenet from BAMA's owner. It seems that storage is becoming a problem for him. I'm posting this to all four groups I

You can play with the INT LIMIT control on the Z-axis board, but it will probably not help much. That is a classic weak-CRT symptom. Does it look like the first photo at http://www.ke5fx.com/crt.html

<david_woodhead@...> wrote: When I trace there Here's a little more info: The front panel command to intensify the graticule for photography works but all I see is the graticule. It completely dims

Hi Group, I`d like to obtain one first mixer for my new/old H/P 8555A plug - in for my 141T Spec/An. Does anyone have one that they don`t want? Ideally, I`d like a fully working one, but non - working

Just acquired an 8568B and have questions.... The graticule is a little out of focus and appears to be over intensified. The trace and on screen characters are very crisp. When I turn down the

make shure that all the screws holding the pcb's are tighten, most of the grounds are closed thru the screws and the chasis.

Hi Mike, I have a paper set now. It is the other guy that needs a set. -Chuck Dr M J DiGirolamo wrote:

Dear list members, I own a 3325A, a nice function generator, however it has an intermittent fault, it resets sometimes, usually it does that during warmup, but once in a while it also resets after a

Hi Chuck, I have a set on microfish. Do you have a reader? 73, Mike, W4XN -----------------

Hi Glenn, Yes I did! I paid something over $350USD for a set of 8505A originals. They come in three, 3 inch, 3-ring binders, and about 50% of the pages are fold out schematics. Each binder is packed

Hi Chuck, I just picked up an 8505A myself. Did you ever get a copy of the manuals for your analyzer? I'm looking for a set myself. -Glenn <cfharris@...> wrote:

Hi Anand, If you go to the Agilent website ( http://www.agilent.com ) and do a Search on "8924", you will see a download for the "8924C/E Assembly Level Repair Manual". On the left-hand side of Page

wrote: the Tx to the cut a 100 in

Didier, this is fine providing that 1) the 5K resistor is at the T-piece end, and 2) from the non T-piece end of the 5K resistor, you put a ~50 ohm resistor from t

W???QFC wrote: Gene, Check http://www.ko4bb.com/Test_Equipment/Counter_Pickup.jpg It uses a common T BNC connector adapter, a short piece of coax cable with a BNC plug, a resistor and a BNC socket.

Hi I am on the lookout for HP 0950-2952 Power supply Schematics. thanks in advance Anand

Thanks for the tip, Bernie!.................................Don.

Check out http://www.glkinst.com/cables/hp_cables.htm This guy is excellent. Bernie

Looking for one rear panel termination[s] plug, as used on the 141T mainframe. Thanking you,....................................Don Collie jnr.

The counter's input stage, whose geometry has about 1/1000 the size and thermal mass of the fuse, will do a great job protecting the fuse. :) A pair of back-to-back Schottky diodes, perhaps the kind