开云体育

These TO220 packaged schottky diodes seem fairly common in switch mode power supplies used in photo copiers and such now. I don't think you should have much trouble finding a replacement. Perhaps you

Hello Tom, Motorola did a lot of Schottky and ultrafast recovery diodes in TO-220 packages. Those were diodes for currents higher than 5 A and to best of my knowledge, none of them were JEDEC

Hi, all. I need help identifying a part on the power supply board of an HP 3325A. It is CR10. But it resembles a TO-220 transistor. There are three separate part numbers on it: 1) 84-0266 (top of

Vintage manuals for sale: (originals except as noted) HP 522B counter $ 5.00 HP A4-C decade counter $ 5.00 HP 5352B freq,

Hello, I Am Looking For A PDF Of The Service Manual, This Unit Is Quite Old, But I Wanted A Challenge. Greyhawk

<higglyblue@y...> wrote: the relationship Hi, Yes there is a manual. My copy is bearely readable. Came from HP microfiche... Check the solid tantalum capacitors on the second board from the top,

<leedyt@a...> wrote: Hi Tom, Contact me by email below. I have a working 4328A and a manual. I can scan it for you. If it whent full scale it could be the batteries or the probe wires. Regards

I recently wrote a program to allow PCs to control and print waveforms from the HP54200A. The program also allows waveforms to be averaged to reduce noise and improve resolution, and it does FFTs.

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the hp_agilent_equipment group. File : /HP54200A programs.zip Uploaded by

Bob I'll take the Boonton 93AD and the Wavetek 157 quote me shipping USPS media mail/Book rate Dave

Hi, I need a copy of pages 7-3 and 7-4 from the HP3320A/B op/service manual. Page 7-3 is the block diagram, and I don't know what is on the back (maybe it's blank). A scan would be fine also, or if

Test Equipment Manuals for Sale (within USA only). Prices do not include shipping and insurance from the Oswego, Illinois area. Money order or check. Fluke 8040A DMM maintenance (op/service)

can it Yes it did spin around.........at first try it would not budge......second try after posting the original query found that more might was needed in the effort and lo and behold it did move

Was thinking of cutting the double banana plug off, and replacing it with Bnc (with the shunt capacitor also). Was also thinking of putting BNC on the amp for both probe and another for the output.

Thanks for the helpful suggestions, I will check the voltage potential on my DVM. Regards Richard Murray

jm I checked the manual on my protek 506 dvm & it said that the test current for diode testing is 1 ma. The diode in question is acting as a switch which is controlled by a bias voltage based on

Gleamfollower Any suggestions on how to test a schotsky diode. Thanks Richard

I do not think that it is current that would kill schottky diode, it is reverse voltage that might do it in. Some of very old meters were putting 100 mA on low ohm range, but I do not think that there

We have a good cross section of HP parts for test gear, plus an extensive on line cross reference for HP semiconductors, and a look up table for many CRTs. you can see this info here:

Couple of ways: 1) See how well it acts as a mixer in the frequency range in question. (This is what I usually test, since the DUT is usually part of a mixer assembly.) 2) Use a curve tracer with