Was thinking of cutting the double banana plug off, and replacing it
with Bnc (with the shunt capacitor also). Was also thinking of putting
BNC on the amp for both probe and another for the output. This also
means putting BNC on the probe too. The cable is .195" dia and heard
that it is 75 ohm but don't remember where. Which leads me to figure
on 50 or 75 ohm connectors (how can you tell by looking at BNC?)
There also is a 100/1 divider available for this probe that connects
to the probe end microdot connector, any facts on what in this little
divider?
The probe goround lead in the manual shows what appears to be the end
screwing into the rubber of the cable strain relief, surely the
rubber does not get used for the threads does it!!! I have another
probe which at least has a threaded hole beneath in the metal, can it
be that my rubber has just spun around hiding the hole?
With a BNC on the end of the probe does it become a 1110a probe?
Any other ideas to spiff up this probe a tad?
Maybe bells or whistles!! Maybe its just getting late!!!!!!!!
Thanks guys
Dave
