开云体育

The IC looks like an old HP traveling wave amplifier, but what’s around it does not look like it was made at HP. The gate voltage (bottom left pin with the wire going to the feedthrough) is quite

Hello Tam, thanks for your kind offer. You can contact me via dk1vi at darc.de Ernst

My data base shows that this transistor has been replaced by 1853-0059. PNP, VCE-55V, IC-5A, PD-150W, FT-3MHZ, SI TO-3. -- This email has been checked for viruses by AVG antivirus software.

Hello, I am looking for the HP 1GG7-4210 MMIC amplifier datasheet or at least the +VD and -VG values for this amplifier Best regards eric

IIRC, the film used for LED displays was not only fairly monochromatic, but polarizing.? The idea was that light going through from the outside would be polarized, change polarization when bouncing

Pay especial attention to the alphabet soup past the part number, and for that manufacturer, try to track it down to a specific outline in the data sheet.? Not all manufacturers give you a link to a

I have a few C# examples which work with quite old devices. Please email me OFF list, as these are customer code and I cannot post them publicly. Tam With best regards Tam HANNA -- Enjoy electronics,

Perhaps the best thing might be to make a new, dual footprint so that either narrow or wide will fit rather than overlaying one on another – which will always produce DRCs. It’s rare that us

Hello Yves, thanks for your detailed reply. I am not familiar with vb.net, so probably there are a few more code lines necessary for initialisation of the program. Maybe you can send me this code.

That problem has bitten me numerous times in the past. What I try to do is to order the chips, then print out the layout on paper ans place the chips to check the spacing.

Hi Ernst, Using the 5350B series meters is not simple with GPIB at first glance. But you have to follow a small procedure: You must put the meter in HOLD mode to begin. - Press the SET key - Press the

What about rubylith tape (like we used to use to make PCB artwork)? 3M makes tape (which is pricey) but you can buy sheets for a few dollars.

I keep looking at my parts and seems the issue with the parts is naming by different vendors.? .Nexperia SO20 is 7.5mm wide while TI SO20 is 5.3mm wide.? Lesson learnt - cant trust the names - need

Here is the pad difference seen on? half of U1 shown with SO20W and other half with both SO20 and? SO20W. Routing is possible but a few tracks and vias had to be moved. SO20W and SO20 overlap. This

Hello, my HBIB system works with 8568B spectrum anaylyzer, 8970A, 34401A and others. However I fail to connect a 5350B to my system. Diag 80 (HPIB diagnosis) shows no errors. Also tried ddifferent

There is a new one in groups.io for Japanese equipment. [email protected] | Messages ( /g/Japanese-Test-Equipment/messages ) The traffic is low, and requests for info

Been there and done that.? At least you don't have two unrelated traces with the same name due to cut and paste.? Next design, then. Harvey

Just checked ..it's too late to change as they did the drilling and imaging the copper . wrote:

The boat has sailed. I redesigned and submitted my boards yesterday. I will see if I can stop production.. [email protected]> wrote:

I wonder if anyone had ?success in obtaining a schematic for this unit. I recently picked up an S331A that shows integrator failure in self test. EEV Blog has some repair guidance for this unit