Been there and done that.? At least you don't have two unrelated traces with the same name due to cut and paste.? Next design, then.
Harvey
toggle quoted message
Show quoted text
On 6/12/2024 1:20 PM, Maciej Kawalkowski wrote:
Just checked ..it's too late to change as they did the drilling and imaging the copper .
On Wed, Jun 12, 2024, 1:18?PM Maciek KawalkQCWski <kawalkowski.m@...> wrote:
The boat has sailed. I redesigned and submitted my boards
yesterday. I will see if I can stop production..
On Wed, Jun 12, 2024, 10:51?AM Harvey White via groups.io
<> <madyn@...> wrote:
I did that when I ordered a 24C256 in the wider package.? It
works well,
except that Eagle complains about overlaps.? Those become
forgivable
errors.? If that is objectionable, then put them on opposite
sides of
the board if convenient.
Harvey
On 6/12/2024 3:30 AM, Mike wrote:
>
> Perhaps make a dual footprint so either will fit, as long as
they have
> the same pin pitch!
>
>
> On Wed, 12 Jun 2024, 01:22 Maciej Kawalkowski via groups.io
<>
> <>, <kawalkowski.m@...> wrote:
>
>? ? ?Harvey
>? ? ?Since I ordered quite a large number of the 74AHCT245 i
think its
>? ? ?better to change the PCB design accordingly. Just more
wasted time
>? ? ?but no additional cost.
>? ? ?Maciej
>
>
