开云体育

It appears that they were all read as 27256s, as per your second paragraph below. Anders' original reads resulted in 32KB files, the size of a 27256. (as you know) This would've resulted in a

I forgot to mention: Anyone of us who has never made a mistake, that was well below his experience level should raise his hand and take a bow? I have been burning EPROMS for nearly 50 years, and

Hi Dave, Wouldn't the mistake have to have been assuming one or more of the 27256 EPROMS was a 27512? That would cause the hex file for the misidentified EPROM to contain a double copy of the

I acquired a new logic analyzer and redid the startup sequence as I was having issues with that logic analyzer. I made the wrong assumptions about AEN . It's actually low when asserted. I will post

It was a simple and natural mistake to make; no one is looking to assign blame. Apparently you had assumed they were all 27256s and read them as such, thus truncating the data from the two

The display screens (for the options) are readable in this listing: https://www.ebay.com/itm/133936523594 I just search for the number. ed

Which reference divider are you referring to? From the 10MHz reference, the 100MHz reference VCO, or the M/N lock reference that feeds the PLL circuitry?As stated, do check the PLL 2 diagnostics/

Hi Martin, Thanks so much !!!! m.

Yeah I noticed that when he did that video. We should ask him if he can provide the updated clips if he still have it! [email protected]> ha scritto:

Great, glad to hear it is all working for other people. Regards Nigel

Hello, I have exactly the same problem , I have a functionnal E3615A but it was dropped and the plastic front panel is broken on its sides. So looking for a spare front panel. Best regards Eric

Hello Dave, If you have the Artek ESA CLIP that's all you can get. From what I saw everyone is using the CLIP from Artek but I noticed in one of the videos from Shahriar Shahramian on the The Signal

If you compare the files with mine, then what did I do wrong all those years ago? Did I miss that not all EEPROMS were the same type or perhaps not supported by the GalepIII? Anyway. Last time I

Great! You took a weight off my chest.

Thanks all. I will check out the NanoVNA. I have a lot of instruments, but no VNA, but I have a HP 1GHz RF signal generator, cannot remember the type offhand and also a HP8116A generator and an

I have a E4402 with the dreaded LO fault that I am trying to fix. I have the CLIPs that cover the 4402 but the RF Deck is not the same as what I have and has the 1GC1-4210 divider. Before I purchase

Hello Now i have digged further into the EXT analyzers—they share these same exact modules ::Analog IF-Digital IF-Frontend controller-Lo synthesizer-Reference and Front End. So some mixing

Rick I programmed the Eproms but not tested yet.? The hex files work just fine on my Tl866 II plus. They make a new version call T48 and its dirt cheap ($50 buck shipped)? I highly recommend

Hello Ok please show me pictures showing where these`missing` modules were ment to be installed!! Have serviced several of these `cheap` MXA look a like. I can tell that they all are real

Thank you Nigel, Dave and Maciej? & Anders, for clearing this up ! I was certain U57 & U58 required c512 EPROMS, & the remaining 6 Roms were c256. I apologize for the? earlier faulty /