开云体育

Hi Don, In my SM J2F1 is listed as 0.125A 125V .281X.093 (hp number 2110-0301) Br, Askild wrote:

Hi, In this thread on eevblog forum: https://www.eevblog.com/forum/testgear/hp856xe-hackers-corner/ It is listed undocumented gpib commands for the 856xE series, one can be used to read any memory

Hi Vladan, Not sure it's possible to calibrate the 8360 with the front panel (really don't know...), normally you do this with the software running on an HP98x6 or a R382 computer and HP power meter

Hello group. Can anyone advise me the rating, and where to get, replacement fuses for the 525MHz channel input protection on a 5350B? The manual that I have has this information missing. Thanking you

Hi Randy, Welcome to the group! I assume that your unit is a 3325A, but both the A and B models are quite similar. Place your scope probe (high impedance) on the A16/A26 AMP OUT pin. If you have

Did you try more than one browser?

New to the group, but have used HP gear for decades. I have a 3325 which appears to have an output attenuators issue. I can see the sync output on my Tek (555) scope, but do not see anything from the

Ron, The 85700A isn’t going to help you much if you plan to replace the NVRAM battery B1 on the video/processor board. The calibration constants have to be manually logged per the instructions in

Do you keep your unit plugged in, AC power to the power cord? I am not overly familiar with the 3336B, but that era of generator were never powered off as long as plugged in (ie. 3335A, 8340A/B,

Was trying to register using my tablet My laptop works but i think i have to wait for verification as it will not allow me to check out. Thanxs for your help Never thought there would be an issue with

Are you trying from a smartphone or a pc? Parts of the Keysight website apparently aren’t optimized for use from a mobile application but work from a pc. Steve

Hi Pierre-Fran?ois, I am sure someone has them, but as you say they are really hard to find. Can the 8360 be aligned manually, using the front panel to make the settings? If so, I would find it much

When I try to submit nothing happens. I work for a custom magnetics company and tried that as well. I can't get past the registration page to order.

Is it giving you a reason? Steve

Can't register to purchase, bummer

On Sat, 29 Feb 2020, Jim Ford wrote: And now it is all trashed. Please never post anything from that stupid piece of junk -- it is buggy as hell and turns everything it touches into turds. > Good.? I

Tim, Don’t have much to go by in a few different 3336 manuals in my possession (looking through PDF files with incomplete sections – don’t have my paper versions handy at the moment) except for

But I will sell it for the same $5500 with out all those add on's. No 8530a, no adapters, std LO cable, no manuals, no rack, etc. Pete wa2odo [email protected]> wrote:

Hi Vladan, Not true, the Service Support Software P/N 0860-10001 for the 8360 series and the Component Level Repair manuals P/N 08360-90077 exist but very herd to find. 73's -- Pierre-Fran?ois, F5BQP

Well, it is true that accessories are hard to find and can be very pricey, so makes it a different deal, of course. Particularly adapters to 2.4. JeffIn a message dated 2/29/2020 1:50:18 PM Eastern