开云体育

I can vouch for the Demi distribution amps. I have four of them feeding all the test equipment in my shop and they’ve worked flawlessly for several years now. Steve WB0DBS

Rich: I just checked out The Demi Distribution amp you recommended to use on my Leo Bodnar GPS Disciplined Oscillator as it outputs only two software adjustable channels from 450 Hz to 800 MHz - I

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the hp_agilent_equipment group. File : /Omni-Spectra Semi-Rigid

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the hp_agilent_equipment group. File : /Omni-Spectra Semi-Rigid

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the hp_agilent_equipment group. File : /Omni-Spectra Semi-Rigid

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the hp_agilent_equipment group. File : /Omni-Spectra Semi-Rigid

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the hp_agilent_equipment group. File : /Omni-Spectra Semi-Rigid

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the hp_agilent_equipment group. File : /Omni-Spectra Semi-Rigid

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the hp_agilent_equipment group. File : /Omni-Spectra Semi-Rigid

I have had good luck with DEMI, Distribution Amp. Available assembled or in kit. Runs my HP Equipment just fine. Tnx Rich KQ6EF http://www.downeastmicrowave.com/product-p/10-4.htm

Jim, I, too, would be interested in a copy of your spreadsheet. I have a T-200/500 kit and have been trying to obtain a copy of the general instructions for the kit for some time. I believe the

Hi, if the 5018 is needed, I have some pulls here in good condition. Regards, Jochen DH6FAZ Am 23.10.2017 um 21:21 schrieb Tobias Pluess tobias.pluess@... [hp_agilent_equipment]:

We used these at the TV stations that I worked for. The inputs "loop through". There is only one output from the amplifier, it goes to eight BNC connectors with a 75 Ohm isolating resistor between the

Hi Calvin unfortunately, I've got no 8340 to offer. However, I have a large collection of old and obsolete ICs. If you tell me what you need, I can have a look. The 7533 is available from Maxim, the

I use GRASS VALLEY GROUP VIDEO DISTRIBUTION AMP. There are a variety of plugins available for these units. I use 8500-8501 with excellent results. I find most test equipment will massage it's input

You guys are awesome!!!I will carefully read the ADC's datasheet to see if there is any viable substitute for it. My repair stories so far is always in RF and pure analog path. This is certainly a

Be careful with the amplifier you pick up. Early on I had the same idea and bought a cheap Asian unit and found out that it only had enough BW for a 6-7 MHz B/W video signal. Another thing to consider

Thanks for everyone that responded. I’ve located one from a member of this group.

If this is for routine use to have all the gear synchronized and show consistent frequencies, then you don't need anything fancy. Pick the reference output from one of the instruments, that seems the

I'm using a 75Ω video distribution amp, works just fine. $10 for 6 inputs, 30 outputs in 2 inputs - 10 out config. I've daisy chained the inputs using the second port on the first one to feed amp