开云体育

yes is a 12 pin Jones connector. Yes I would be interested in that information.Either reply here or send me a e-mail dmac1054@.... <tractorb@i...> wrote: pot- I

If its a 12 pin jones connector its probably for a retransmitting pot- I can give you that info if you still need it. Dave Brown Christchurch, NZ

Hello Tom, I have a Motorola's MC12040P, what is plastic DIP, as oposed to L part, a ceramic package. I can mail you one piece if that would do it for you. Regards Miroslav Pokorni

Folks, Looking for the following ECL chip HP P/N 1820-1344 which crosses to Mot MC12040L Phase detector. Thanks Tom

dmac1054@... writes: Thank you, Doug. I will! Regards, Don

Hello Don, The old age does not lend itself to quick thinking. I just sent you an e mail offering to send you few panel nuts and did not think that you were talking about "speed nuts", but then you

Those guys might have a minimum order. I just remembered that I have few from a DEC's rack. They are square piece of metal, about 3/16 " thick with 10-32 thread cut and a spring retainer. If just few

Might try http://www.tinnerman.com/ Doug Agilent/HP The part is an a "support part for as work with your head

Thought I'd ask the group: I'm looking for a source for the C-clip "speed nuts" used in Agilent/HP equipment rack rails, such as in the N4043A ( nee 1181B ) cart. The part is an Agilent PN

I need the wiring for the plug on the back of this unit. thanks doug

Hi All, Just picked up an HP 651B and have a few problems. For one thing the unit seems to be extremely sensitive to the "band" selector switch, and the 10MHz range in particular. Switching to it

BTW, these use the COOLEST display decoders!!!

Hi group. I have a couple of old Nixie display counters. A 5214L, and a 5201L. It did take me a while to figure out the '14, but now understand what it does in all its modes. The '01 is

Hi there, Also in computer power supplies. The Bat signal. Regards Ray

These TO220 packaged schottky diodes seem fairly common in switch mode power supplies used in photo copiers and such now. I don't think you should have much trouble finding a replacement. Perhaps you

Hello Tom, Motorola did a lot of Schottky and ultrafast recovery diodes in TO-220 packages. Those were diodes for currents higher than 5 A and to best of my knowledge, none of them were JEDEC

Hi, all. I need help identifying a part on the power supply board of an HP 3325A. It is CR10. But it resembles a TO-220 transistor. There are three separate part numbers on it: 1) 84-0266 (top of

Vintage manuals for sale: (originals except as noted) HP 522B counter $ 5.00 HP A4-C decade counter $ 5.00 HP 5352B freq,

Hello, I Am Looking For A PDF Of The Service Manual, This Unit Is Quite Old, But I Wanted A Challenge. Greyhawk

<higglyblue@y...> wrote: the relationship Hi, Yes there is a manual. My copy is bearely readable. Came from HP microfiche... Check the solid tantalum capacitors on the second board from the top,