开云体育

Adding: the hardware I have is Raspberry Pi 3 Model B V1.2, 2015 CMD line reads as follows: dwc_otg.lpm_enable=0 console=ttyAMA0,115200 console=tty1 root=/dev/mmcblk0p2 rootfstype=ext4

Good to know. Thanks Brian!

Hey Tino, Hmmm...this may change my setup. I actually HAVE a rPi. It came with my telescope(used). The only problem is the previous owner couldn't tell me the password. Maybe I can dedicate the rPi to

Michael Astroberry pi vs stellarmate pi https://indilib.org/forum/general/6858-stellarmate-vs-astroberry-what-is-the-difference.html Chuck

Sorry that should have read INDI and not Indian

Thank you guys for your insights and success stories. I'll get into the jam in 2022 (raspberry jam anyways) Happy Holidays! Michael

None from the Gemini standpoint (at least that I’m aware of), but you will probably run across quirky behavior on the AAP. They based it on the Indi drivers, which are community developed and

preconfigured? In a very general sense, yes. But ZWO took the Indian foundation and built apps on top of it, so it’s customized to the point that you wouldn’t recognize it compared to say ekos.

I am using a Raspberry Pi 4 with 8GB of RAM, which is more than plenty. The Pi can handle pretty much everything in terms of astrophotography. Mine is setup to create a hotspot automatically on boot

Tino, I'm interested bin the Raspberry Pi approach too....for experimentation. Can you recommend a "pick list" for such a project? What Raspberry Pi to get etc. Time for me to play Santa to ...

Isn't the ASI Air basically a (more expensive) raspberry pi that comes preconfigured? If so it should be running linux with INDI, EKOS and KSTARS. You will have to install the INDi Driver (INDI is the

Nick, Not having an ASI Air, I cannot say. You'll have to experiment, or contact ZWO for their ASIAir instructions. The Gemini-1 uses only a standard serial port at 9600 baud to pass instructions back

Michael and Howard, Thanks for the reply. It did take a few reboots to get back on track. It’ll be a week or so before we have clear skies to test the system. Are there any concerns running the

I think Michael is spot on, but be sure you are in counter-weight down (CWD) position for the cold boot. good luck Howard

Hi Nick, I'll guess: Start over with a Cold Boot. That erases your model data that I'm guessing is messing your system up. Then run your system as you did the first successful night. After your first

Alright gents... It seems my G11 (circa 2007) is a little sensitive when working with the ASI Air Pro (AAP). I've thumped my head enough on the proverbial wall many - many times. Thinking it's time to

Hi Andy, That's what I think Howard should try. Without seeing the ASCOM logs, I can't guess as to what each software is doing when trying to nudge. If it really is using pulse guiding, then guider

Paul?Do you think it’s possible that MaxIm is using the guide command signal for the move command? ?If so, maybe this is tied to Howard’s issue if he has Precision Pulse Guide checked. ?I

That's good advice for Gemini 1 / Level 4. This was fixed in Gemini-2 L5, so that precision pulse-guiding became the default and only available option. For Gemini-1, turn it off if it's turned on.

Howard,?I just had an issue similar to yours. ?I also use MaxIm. ?During an RA guide correction, my G11 would run off in RA indefinitely until I intervened. ?I found that I had Precision Pulse